Compac WD60 G2 Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Outdoor-Wagen Compac WD60 G2 herunter. Compac WD60 G2 14 Seiten. Wheel dolly

Operating Instructions:

Placement of rol

Placement of rollers

lers on the lifting beam:

lers

The rolls which sits on the lifting beam, can be adjusted to suit the

wheels in the best way, when to be lifted, there are 4 setting options.

Remove cotter pin (F) (See Fig. 20) from the roller to be moved.

Move the roller to the desired position / hole in the lifting beam

Insert the pin into the roller again

Wheel / cargo location on the lifting beam

Wheel / cargo location on

By setting the fork spacing, the wheel can be picked up standing on the floor.

With forks placed in lowest position, the can be positioned under the wheel, as deep as

possible

in the lift rented. (See Fig. 21)

Note that the wheel is up against the inner-bar of the lifting beam

Removing the wheel:

When the vehicle is lifted to working height, push the wheel dolly's rolls under the wheel to be

removed. Be careful that the wheel dolly does not make contact with the actual vehicle.

Pump with foot pedal (A) (Fig. 12), until the rollers on lifting beam support's the wheel,

be sure that the tyre will be up against the lifting beam (Fig. 13).

Follow the instruction in the "Warning" section (point 2. – 3.) Pull the wheel free of the vehicle.

Lower the wheel to the lowest position with handle (E), (turn it counter clockwise to lower the

lifting beam, rotate it clockwise to stop lowering) (Fig. 16).

Now the wheel can be transported away from the vehicle. (See page 4 section "Transport with

wheel").

Removing the wheel from the wheel dolly: grab the wheel and roll it off the support rollers and

over the wheel dolly's leg.

Fig. 12

on the lifting beam:

the lifting beam.: .: .: .:

the lifting beam

Fig. 20

Fig. 21

Fig.

Fig. 16