Andrea M3000C Betriebsanleitung & Sicherheitshandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Betriebsanleitung & Sicherheitshandbuch für Gefrierschrank Andrea M3000C herunter. Andrea M3000C 2 Seiten. Evaporative coolers
Seite druckenOperating Instructions - M3000L Evaporative Coolers
Caution - check voltage
Check the voltage of the cooler before plugging in to power
outlet. Use only the rated voltage on the rating plate on the rear
of cooler.
Riling with water
Turn the cooler off and disconnect from the electrical supply
before filling. The water inlet door Is opened by pulling it at the
top and fill the appliance with clean water. The water capacity is
18 litres. The minimum amount of water needed for the pump
to operate is 4 litres. Try to position the cooler where you wish
to use It before you fill to avoid unnecessary spillage. Do not
overfill as water will spin out of the cooler. The cooler is full
when the water level meter Indicated the highest reading. Close
the water inlet door after filling.
How to get the best cooling performance
Place the cooler with its back near an open window or door so
it can draw 100% fresh air. Open another window or door on
the opposite side of the room for 'flow through' ventilation. This
cooler will not cool properly in a closed room.
Safety Instructions
As this cooler contains water, ensure it is moved carefully and is
not tilted as water may spill. Always switch off and remove the
plug before servicing the cooler. Do not store anything on top of
the cooler.
Air Direction Control
Adjust the air guide vane levers as required. They are located at
the top of the front grille.
Cooling
When this appliance is used as an air cooler it should be filled
with water and the 'cool' knob turned to the 'ON' position.
Controls
Air Direct control
Water inlet door
(shown closed)
Click
www.andrews-sykes.com
Water level meter
Controls
Resevoir
Fan Speed
set the fan knob to the required position. Low Fan speed '1' is
selected for quieter conditions.
Fan Only (ventilation)
The cooler may be used as a fan only. This is set by turning the
'cool' (cooling) knob to the 'off' positions.
Conditions of Aspen filter pads
We recommend that when the cooler Is first used it should be
run with the Air set on No. 3 and the Cool on for 10 minutes,
this will condition the new filter pads.
or Call Us Free
0800 211 611