3M 3MPF301 Installations- und Betriebsanleitung für
Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für für Water Filtration Systems 3M 3MPF301 herunter. 3M 3MPF301 4 Seiten. Advanced whole house filtration system for well/city water
Seite drucken
Installation and Operating Instructions for
™
3M
Advanced Whole House Filtration System for Well Water
™
3M
Advanced Whole House Filtration System for City Water
Read, understand, and follow all safety information contained in these instructions prior
to installation and use of the 3MPF201 and 3MPF301 Series Filtration Systems. Retain
these instructions for future reference.
The 3MPF201 and 3MPF301 Filtration Systems are intended for use in fi ltering potable water in whole
house applications and have not been evaluated for other uses. These fi lters are typically installed at the
point-of-entry, and must be installed as specifi ed in the installation instructions by a qualifi ed professional.
WARNING
WARNING
Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury and/or property damage.
CAUTION
CAUTION
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury and/or property damage.
CAUTION
CAUTION
Indicates a potentially hazardous situation, which, if not avoided, may result in property damage.
To reduce the risk associated with choking:
• Do not allow children under 3 years of age to have access to small parts during the installation of this product.
To reduce the risk associated with the ingestion of contaminants:
• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
To reduce the risk associated with hazardous voltage due to an installer drilling through existing electric wiring or water pipes in the area
of installation:
• Do not install near electric wiring or piping which may be in path of a drilling tool when selecting the position to mount the fi lter bracket.
To reduce the risk of physical injury:
• Shut off inlet water supply and depressurize system as shown in manual prior to fi lter removal.
To reduce the risk associated with property damage due to water leakage:
• Read and follow Use Instructions before installation and use of this system.
• Before starting installation, shut off main water supply and drain pipes.
• Installation and Use MUST comply with all state and local plumbing codes.
• Protect from freezing, remove fi lter when temperatures are expected to drop below 40° F (4.4° C).
• Do not install systems in areas where ambient temperatures may go above 110° F (43.3° C).
• Do not install on hot water supply lines. The maximum operating water temperature of this fi lter system is 100°F (37.8°C).
• Do not install if water pressure exceeds 125 psi (862 kPa). If your water pressure exceeds 80 psi (552 kPa) you must install a pressure
limiting valve. Contact a plumbing professional if you are uncertain how to check your water pressure.
• Do not install where water hammer conditions may occur. If water hammer conditions exist, you must install a water hammer arrester. Contact
a plumbing professional if you are uncertain how to check for this condition.
• Where a backfl ow prevention device is installed on a water system, a device for controlling pressure due to thermal expansion must be installed.
• Do not use a torch or other high temperature sources near fi lter system, fi lters, plastic fi ttings or plastic plumbing.
• On plastic fi ttings, never use pipe sealant or pipe dope. Use PTFE thread tape only, pipe dope properties may deteriorate plastic.
• Take care when using pliers or pipe wrenches to tighten plastic fi ttings, as damage may occur if overtightening occurs.
• Do not install in direct sunlight or outdoors.
• Do not install near water pipes which will be in path of a drilling tool when selecting the position to mount the bracket.
• Mount fi lter in such a position as to prevent it from being struck by other items used in the area of installation.
• Ensure that the location and fasteners will support the weight of the system when installed.
• Ensure all tubing and fi ttings are secure and free of leaks.
• Shut off fuel or electric power supply to water heater after the water is shut off.
• The disposable replacement fi lter MUST be replaced every 12 months at the rated capacity or sooner if a noticable reduction in fl ow rate occurs.
• Failure to follow instructions will void warranty.
• Allow a minimum of 3" (7.6 cm) clear space under fi lter to facilitate fi lter change.
• Install with the inlet and outlet ports as labeled. Make sure not to reverse connections.
Homeowner: Please retain for operation and future maintenance instructions.
3MPF201
3MPF301
EXPLANATION OF SIGNAL WORD CONSEQUENCES
WARNING
CAUTION
IMPORTANT NOTES