Advanced Native Technologies START 16B Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Mikrofonanlage Advanced Native Technologies START 16B herunter. Advanced Native Technologies START 16B 19 Seiten. Pll diversity uhf wireless systems

Seite drucken

Series

the synchronization, the receiver's display is lit steadily on the selected channel

(frequency).

4 MINI XLR-M INPUT

Connected to this input the supplied PH-90 Headset or the signal of other sound

sources.

5 POWER ON AND BATTERY STATUS INDICATOR

GREEN: Transmitter activated (ON), charged batteries.

RED: Immediately replace the batteries.

6 GAIN SELECTOR

There are three different gain settings:

Mic: for supplied headset microphone and other microphones

0 dB: low output level instruments

-10dB: high output level instruments

7 BATTERIES COMPARTMENT

To replace the batteries, lightly press on the sides of the cover and lift forward. Take

out the old batteries, and insert two new batteries (respecting the compartment

icons) then close the lid. Remove the batteries from the receiver when not in use

for extended periods.

WEARING THE BELTPACK RECEIVER:

Clip the receiver to a belt or to the

shoulder strap of your guitar. For better

fastening reliability it's preferable to

secure it as shown in the figure, then

fasten it in a way that the belt is tight

from the clip.

3 | TIPS FOR BETTER USE OF THE SYSTEM

• Aim the transmitter to the receiver to achieve a "direct visual contact" between

devices, without any interposed obstacle.

• Avoid placing the receiver near metal objects/surfaces or close to digital equipment

(CD players, computers, etc.).

START 16 Series

User manual |

• Place the receiver in such a way that is far from a wall and that is at least

1 meter (about 3 feet) above the floor.

• Cell phones, two-way radio equipment or similar devices may disturb

the radio transmission between the transmitter and the receiver, so they

should not be used close to the transmission system.

4 | TROUBLESHOOTING

PROBLEM

LEDS

No sound or very

Receiver ON/OFF

low sound level.

LED turned off.

Power LED turned off.

Receiver RF LED turned on.

Transmitter LED turned on.

Batteries status LED is red.

Distortion or unwanted

Receiver RF LED

interferences.

turned on.

Batteries status

Increasing distortions.

LED is red.

Great intensity difference

when the same source

is via cable, or in case of

connection with other

guitars or microphones.

SOLUTION

Make sure the unit is properly

connected.

Make sure the power supply is

properly connected to the receiver.

Raise the volume.

Raise gain on transmitter.

Check the connections between

receiver and amplifier or mixer.

Don't place the receiver close to

metallic objects.

Check that the transmission

space ("visual contact") between

transmitter and receiver is free.

Approached the transmitter to the

receiver.

Make sure the transmitter and

receiver share the same frequency.

Replace batteries.

Remove possible sources of

interference such as CD players,

computers, digital broadcast

sources, etc.

Replace batteries.

Set properly the transmitter gain

selector and the receiver volume.

START 16 Series

| User manual