Atlantic ACI Visio Benutzerhandbuch - Seite 14

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Warmwasserbereiter Atlantic ACI Visio herunter. Atlantic ACI Visio 19 Seiten.

Seite drucken

A water heater requires little maintenance for

the user : operating the safety valve regularly

(refer to the manufacturer's instructions).

Check periodically if the pilot light is on. If not,

To make the performances of your heater last for many years it is necessary to have the equipment inspected

Switch off the electricity power supply to the

heater (protection) and disconnect the wires to

the thermostat terminals.

Remove the thermostat and its plastic base

after having disconnected the different wire

bundles.

Drain the tank and disassemble the heating

assembly.

Remove any deposits in the form of sludge or

scale on the bottom of the tank and clean the

ducts of the heating elements and the thermo-

stat. Do not scrape or tap scale stuck to the

walls, since this could damage the coating.

The anode is made of titanium and no inspec-

tion or replacement is necessary.

In regions in which the water is very hard Th

> 20°F, the use of a softener does not make our

guarantee null and void provided that it is set in

accordance with standard practice, and that it is

regularly checked and maintained.

Proceed as follows when you want to drain

your water heater (operation necessary for des-

caling or if the heater must remain out of ope-

ration in a room in which frost is possible):

a) switch the electricity power supply off

b) close the cold water inlet

c) open a hot water tap

d) open the safety valve drain tap

If there is a problem ,no heating or steam

escapes when the valve is open, switch the elec-

Domestic maintenance

Maintenance by a specialist

every two years by a specialist, who shall proceed as follows :

User recommendations

contact your local installer.

Reassemble the heating assembly using a new

seal, and tighten the nuts moderately and gra-

dually (crosswise).

Fill the water heater leaving a hot water tap

open; when water comes out of this tap, the

water heater is full.

Check waterproofness at the seal and then

and only then put back the thermostat and its

base and reconnect the electricity power supply.

Check again the next day to make sure that

the seal is not leaking, and retighten the nuts

again slightly if necessary.

Check the condition of accessories and wires.

Clean the sheath inside to remove scale.

tricity power supply off and inform your instal-

ler.

Note that the water storage temperature used

to be 80°C before.

For safety reasons it is now only 65°C +/- 5 in

the tank. Consequently, the amount of hot water

available with a heater of the same capacity may

be smaller.

To reduce the risk of scalding:

- In toilet facilities, the maximum temperature of

the hot water is restricted to 50°C at the outlet

points;

- In other facilities, the temperature of the hot

water is restricted to 60°C at the outlet points.