Atlantic VERTIGO 841258 Installations- und Betriebshandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Warmwasserbereiter Atlantic VERTIGO 841258 herunter. Atlantic VERTIGO 841258 12 Seiten. Enamelled steel tank, for horizontal installation only the hot water outlet must be at the top, 25/40/65/80 litre
Seite drucken
6. Installation of a vertical or horizontal wall mounted device: To
allow the replacement of the heating element leave a free
space of 500mm between the tube ends and the wall or fixed
furniture.
7. Switch off the power before removing the cover, to avoid any
risk of injury or electric shock.
8. The installation must be equipped, upstream of the appliance,
with a bipolar cut-out device (fuse, breaker switch) respecting
local regulations (30 mA earth-leakage breaker).
9. If the supply cord is damaged, it must be replaced by a special
cord or assembly available from the manufacturer or the after
sales service.
10. Always connect the earth conductor of the cable to the
earth ground wire or connect the earth conductor to the
appropriate terminal identified by the symbol
11.
Mandatory installation of a safety device in a frost free
location (or any other new device which limits the tank
pressure) to 0.7 or 0.9 MPa (7 or 9 bar) according to the
nominal pressure, with a size of 1/2" in the input of the water
heater, respecting the local regulations
12.
Operate regularly the discharge of safety device to prevent
scaling and check that it is not blocked.
13.
Hydraulic accessories should not be located between the
safety valve and the cold water inlet. A pressure reducer (not
supplied) is required when the water supply pressur e exceeds
0,5 MPa (5 bar) and will be fitted on the main supply.
14.
Connect the safety device to an unpressurised outlet pipe
in a frost free location, with a continuous slope to evacuate
water during heating up or draining the water heater.
15.
The pipes used must support 1 MPa (10 bars) and 100° C.
7
.