Atlantic Technology 44-DA Gebrauchsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Redner Atlantic Technology 44-DA herunter. Atlantic Technology 44-DA 8 Seiten. Dolby atmos-enabled speaker

Instruction Manual
Speaker Placement
Figure 8: Atmos Speaker Configuration
(7.1.4 system shown)

Connecting Your System

We recommend that you connect your system using high quality dual
conductor stranded wire of 16 gauge or heavier, for lengths up to 25 feet
(8m). Remember, the lower the gauge number, the heavier the wire. Use
heavier gauge wire for longer runs. Please contact your audio/video dealer
or installer for specific cable recommendations and further information
regarding special circumstances. The terminals themselves are designed to
allow the use of very heavy speaker wire or angled pin connectors.
WARNING: To prevent risk of electrical shock or damage to your
equipment, always switch off the amplifier or receiver when making
any system connections.
You can connect your speakers by using angled pin connectors, or you can:
1. Remove ½"(13mm) of insulation from each wire end.
2. Twist the stranded wire together, keeping the two ends
separate.
3. Place the appropriate wire through the postholes in the
connectors. These holes are revealed when you push on the
connector's cap.
4. Release the cap to "grab" the wire.
We recommend that you check your local electrical codes to make sure that
you are not using improper connectors.
It's important to observe polarity while making speaker connections:
Red (+) terminals on the amplifier to red (+) on the speaker, black (–) on
the amplifier to black (–) on the speaker.
Look carefully at the wires you are using and note that one of the conduc-
tors of each pair will typically be identified either by color, printing on the
outer jacket, ridges on the outer jacket, or a thread intertwined with the
wire strands.
By convention, the marked wire is connected to the red (+) terminal.
Whether you are connecting a complete system, or adding a single speaker
component to your present system, the wiring should look like the system
wiring diagrams on the opposite page. Because terminology varies among
manufactures please consult your A/V Receiver or Processor's instruction
manual to identify the proper terminals to use when connecting Dolby
Atmos-enabled speakers. In many cases they will be identified as either
Dolby Atmos or Elevation or Height channels.
WARNING: Before turning on the amplifier, be certain that no stray
wire strands are touching across any terminals as this might damage
your amplifier.
Connecting Your System
5