Atlantic Technology IWTS-14 LCR Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Redner Atlantic Technology IWTS-14 LCR herunter. Atlantic Technology IWTS-14 LCR 8 Seiten. Iwts series in-wall theater system speakers

Seite drucken

Installation

Installing the Mounting Frame

cause the attached clamps to rotate and position themselves properly

behind the wall.

Continue to tighten until the frame is snug in the wall. You want the bezel

to conform to the wallboard, and the frame not to rattle from the speaker's

vibration, but be very careful not to overtighten the screws.

Painting the Speaker Assembly

The clamping mechanism allows

the wall material to range from

½ to 1½ inches (13 to 38 mm) in

thickness. There must be a mini-

mum depth behind the wall face

of 3

⁄

" (92 mm). As noted above,

be sure to keep the edges of the

cutout at least ½ inch (13 mm)

away from any stud or obstruc-

tion, as the rotating clamps will

not operate properly if you don't.

Insert the frame into the cutout

and using a level or square care-

fully align it so it is level. Tighten

the mounting screws, which will

The white plastic frame and the

metal grille may be left as is, or

painted to match your décor. You

can paint the frame before or after

it is installed in the wall. Spray

painting (using slightly thinned

paint) is the best method to use for

painting the grille. After painting

the grille, use air pressure to "blow

out" any grille holes that are filled

in with paint.

Speaker Connection and Assembly

Strip about ½" (13 mm) of insulation from the connecting wires. Connect

them to the appropriate push terminal, being careful to observe polarity

(positive to the red terminal, negative to the black terminal).

Installing the Speaker Enclosure into the Frame

Once the frame is mounted in the wall, the speaker simply fits into the

frame. Note that there is a gasket around the edge of the MDF baffle. This

gasket ensures an airtight fit between the baffle and the frame. Therefore,

the baffle may fit tightly in the frame. This is normal.

Use the included screws to attach the baffle to the mounting frame, but be

very careful not to overtighten the screws.

IWTS Series In-Wall Theater System Speakers