Electrolux RH30WC60GSB Handbuch für Gebrauch und Pflege - Seite 41
Blättern Sie online oder laden Sie pdf Handbuch für Gebrauch und Pflege für Lüftungshaube Electrolux RH30WC60GSB herunter. Electrolux RH30WC60GSB 44 Seiten. 30" and 36" free-standing range hood
Seite drucken
Care and cleaning
Care and Cleaning
The eficiency of the range hood system depends on
the cleanliness of the intake and filters.
The frequency of cleaning depends on the amount
and type of cooking.
•
Do not use the ventilating system without the
filters in place or with grease-laden filters or
surfaces.
Lights
Before replacing the lamps, switch power off at
service panel and lock service panel disconnecting
means to prevent power from being switched on
accidentally.
WARNING
To avoid risk of fire and explosion do not use
flammable liquids or solvents.
Always unplug or disconnect the appliance from the
power supply before servicing.
WARNING
Be sure the entire hood (including the filters and light
bulbs) has cooled and grease has solidified before
attempting to clean any part of the appliance.
Filters
The metal grease #1tersare made of stainless steel
anodized aluminum and are long lasting.
To Remove The Metal Grease Filter
•
Turn the fan and lights o%.
•
Pull the spring release handle.
.°°_,
....
..***
/
To Replace The Metal Grease Filters
•
Reverse procedure.
To Clean Filters
•
It is recommended that the filters be washed at
least once a month; they can be washed by hand
or in the dishwasher.
•
Drain water through edge holes and let each filter
dry thoroughly before replacing it.
NOTE:
Turn off the lights and fan. Allow the
lights to cool before handling.
Replace lights
per instructions.
If new lights do not operate,
be sure lights are inserted correctly before
calling service.
Replace Lights
•
Remove the inner lamp lens cover by inserting a
small flat blade screwdriver into each of the three
slots and gently prying it free.
NOTE: Do not remove the outer trim ring (lamp
assembly).
Outer
Inner
ring
ring
\
The glass lens and inner trim ring are 2 pieces
loose fitting. Be careful when removing the trim
ring that the glass lens does not fall out.
•
Grasp the bulb and pull it straight out from the
lamp socket.
•
Replace with 120 volt, 40 watt halogen bulbs with
a G9 base SUITABLE FOR USE IN OPEN
LUMINAIRES.
Follow package directions, wear gloves, do not
touch bulb with your bare fingers.
_
Bulb
•
Replace inner cover by
inserting the three
retaining tabs into the
three slots and pressing
them firmly in place.
NOTE: Once you have replaced the light bulb,
make sure to put back the glass in its place.