Electrolux RH36PC80GSB Handbuch für Installation, Gebrauch und Pflege - Seite 12
Blättern Sie online oder laden Sie pdf Handbuch für Installation, Gebrauch und Pflege für Lüftungshaube Electrolux RH36PC80GSB herunter. Electrolux RH36PC80GSB 21 Seiten. 36” and 42” island range hood
Seite drucken
12
Installing the hood
Ceiling ducting
•
Use the template previously installed to prepare a
8 - ½" hole in the ceiling for ductwork.
RANGE
When the Island is installed in a 10' Ceiling,
35" is the closest distance we can have from
the cooking surface. 35" is the recommended height
RANGE
When the Island is installed in an 8' Ceiling, 30" is
the longest distance we can have from the cooking
surface. 30" is the recommended height 24" - 30" for
electrical cooking surface
Making the electrical connections
Electrical Shock Hazard
Warning: turn off power at the service panel before
wiring this unit.
120 V AC, 15 or 20 Amp circuit required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE.
50" max
extension
10' = 120"
Ceiling Height
35"
(Minimum
Installation Height)
36"
30" min
extension
8' = 96"
Ceiling Height
(Maximum
30"
Installation Height)
36"
TO PROTECT YOU AGAINST ELECTRIC SHOCK,
THE GREEN AND YELLOW WIRE MUST BE
CONNECTED TO THE GROUNDING WIRE IN
YOUR HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR
REMOVED.
Failure to do so can result in death
or electrical shock.
•
Remove junction box cover and knockout on the
top left side.
•
If not already done, install 1/2" conduit connector
in j- box.
NOTE: This connector is not included with vent hood.
House
wiring
UL listed
wire nut
•
Run black (live), white (neutral), and green (earth)
wires (# 14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2" conduit from power
supply to j- box.
•
Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j - box respectively.
•
These connections should be done always
making reference to the electrical diagram found
inside the hood.
•
Close j - box cover and reapply screws.
Knockout
Junction box
cover
Metal electrical
conduit