Bosch 6 Series Montage- und Gebrauchsanweisungen - Seite 7

Seite drucken

Bosch 6 Series Montage- und Gebrauchsanweisungen

Aligning the doors

When you found the doors are not at the same level,

you can use a spanner to adjust the fridge door.

Only the fridge door can be adjusted.

To raise the fridge door, turn the bolt (1) anticlockwise.

To lower the fridge door, turn the bolt (1) clockwise.

Once in position, lock the nut (2).

Connecting the appliance

Have a technician install and connect the appliance

according to the enclosed installation instructions.

Do not remove the transportation protection devices

from the shelves and storage compartments until the

appliance has been installed.

Apart from statutory national regulations, you should

stick to the connection terms relating to the local

electricity company.

After installing the appliance, wait at least 1 hour until

the appliance starts up. During transportation the oil in

the compressor may have flowed into the refrigeration

system.

Before switching on the appliance for the first time,

clean the interior of the appliance

(~ chapter "Cleaning the appliance").

Electrical connection

Warning – Risk of electric shock!

If the length of the mains cable is inadequate, never

use multiple sockets or extension leads. Instead,

please contact Customer service for alternatives.

The appliance must be connected to a permanently

installed socket.

The socket must be near the appliance and also freely

accessible following installation of the appliance.

The appliance complies with protection class I.

Connect the appliance to 220-240 V / 50 Hz alter

nating current via a correctly installed socket with

protective conductor. The socket must be protected

by a 10 A to 16 A fuse or higher.

For appliances operated in non-European countries,

check whether the indicated voltage and current type

match the values of your electricity supply. The rating

plate is situated in the bottom right-hand side of the

appliance. The mains cable may be replaced by a

technician only.

Warning

Never connect the appliance to electronic energy saver

plugs.

Our appliances can be used with mains and sine-

controlled inverters. Mains-controlled inverters are used

for photovoltaic systems which are connected directly

to the national grid. Sine-controlled inverters must be

used for isolated applications (e.g. on ships or in

mountain lodges) which are not connected directly

to the national grid.