Electrolux AIRSPEED ZAS1000A Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Staubsauger Electrolux AIRSPEED ZAS1000A herunter. Electrolux AIRSPEED ZAS1000A 12 Seiten. Airspeed technology
Auch für Electrolux AIRSPEED ZAS1000A: Benutzerhandbuch (12 seiten)

Seite drucken

How to Maintain Mini turbo nozzle

1) Turn nozzle onto back

side. Remove 1

screw.

Thermal Cut-Off

This vacuum has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum switches off,

turn the switch to off position and unplug the vacuum. Check the vacuum for a possible source of overheating such as a

full dustbin, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before

attempting to use the vacuum. After the 30 minute period, plug the vacuum back in and push the on/off switch On ( I ). If

the vacuum still does not run, please call Electrolux Customer Care Helpline.

Service

Should you require service on your Electrolux vacuum,

please telephone Electrolux Customer Care HELPLINE

on 0800 222 825. Before requesting service, please check

whether your problem can be resolved in the Trouble

shooting section on page 10.

New filter pads, brush rolls and drive belts can be obtained

from Electrolux Retailers. If difficulty is experienced in

obtaining spares, please contact Electrolux Customer Care

HELPLINE.

Service Checklist

• If your vacuum will not operate, check the plug

connection and mains fuse.

• Never allow the dustbin to become so full that it impedes

the air flow, thus reducing the cleaning efficiency of the

machine. The character of household dust and its effect

on the air flow through the machine may vary

considerably. Fluffy dust allows air to pass through

readily whereas fine powdery dust or proprietary cleaning

powders pack tightly in the dustbin, offering greater

resistance to air flow and will reduce cleaning efficiency

if the cup becomes overloaded.

• Always store your vacuum and spare dust filters in a

dry place.

• Renew the filter pads regularly. This is essential toensure

continued high filtration of dust particles.

2) Rotate lower part of

cover down over

brush and lift off cover.

3) Clear blockage from

brush roll area. Use

scissors to clip

threads or hair.

• Sucking up such items as stockings, clippings of cloth,

sizeable pieces of paper, wrappings from cigarette

packets or sweets etc., may block the hose. Electrolux

regrets that the clearing of blocked hoses cannot be

regarded as service that can be given free of charge,

under the warranty. Should a blockage occur, first

disconnect the vacuum from the electricity supply, refer

to section headed "How to Clear a Blockage". If these

operations are not successful, contact Electrolux

Customer Care HELPLINE 0800 222 825.

• Never pick up hot cinders or lighted cigarette ends.

• Make certain that your vacuum does not come into

contact with water or any other liquid. It is not

designed as a wet pick up vacuum, and must never

be used on damp carpets or wet floors.

Important - in the event of the mains supply cable of this

vacuum requiring replacement, we recommend that this

be carried out by Electrolux Service Staff.

Spares

New filters, brush rolls and drive belts can be obtained

from Authorised Electrolux Dealers and electrical retailers.

If difficulty is experienced in obtaining spares please call

Electrolux Customer Care HELPLINE 0800 222 825. or

visit our website at www.electrolux.co.za

4) Place cover back into

position. Tighten

screw.