Electrolux Beam Alliance Betriebshandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Betriebshandbuch für Staubsauger Electrolux Beam Alliance herunter. Electrolux Beam Alliance 16 Seiten. Central vacuum system
Auch für Electrolux Beam Alliance: Betriebshandbuch (36 seiten), Betriebshandbuch (13 seiten)
Seite drucken
The central vacuum system is designed for dry pick up of household dirt and dust and is not intended
to pick up liquids. Avoid picking up hard or sharp objects with the system to prevent hose and plastic
pipe damage or clogs. This central vacuum system is intended for household use only.
Service Information
The instructions in this booklet serve as a guide
to routine maintenance. For additional information,
contact your local authorized dealer/distributor.
Rating Plate
The style, model and serial numbers are indicated
on the rating plate located on back left side of
power unit. For prompt and complete service
information, always refer to these numbers when
inquiring about service (refer to Figure 1).
1.0 INSTALLATION
1.1 Planning
If your home already has a system of plastic pipes and inlet valves, you are ready to install the power
unit, (refer to Install Central Vacuum section 1.3). If not, you can contract a professional to have the
central vacuum system installed. Contact your local authorized dealer/distributor if you have any
questions.
1.2 Central Vacuum Location
The central vacuum should be located away from
the general living area, yet accessible so you can
remove the dirt bucket and inspect the vacuum. A
typical location would be in a garage or utility area
where emptying the dirt bucket would be more
convenient. Other suitable locations are in the
basement, laundry room or a ventilated storage
room.
1.3 Central Vacuum Installation
The vacuum hangs on the mounting bracket
which is screwed to the wall. The center of
the mounting bracket should be about 122 cm
(48 inches) from the fl oor to allow convenient
removal of the dirt bucket. Mount unit at least 30
cm (12 inches) from the fl oor, ceiling and corner
sidewall to insure adequate ventilation for motor. If
mounting on plaster or panel walls, ensure screws
enter studs. If mounting on concrete wall, drill the
wall with a masonry bit and insert the appropriate
wall anchors (refer to Figure 2).
GENERAL INFORMATION
Figure 1
Figure 2
R
5