Bosch Series 4 Gebrauchsanweisung - Seite 28

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Staubsauger Bosch Series 4 herunter. Bosch Series 4 44 Seiten. Free standing cooker
Auch für Bosch Series 4: Gebrauchsanweisung (24 seiten), Handbuch für Installation und Gebrauch (16 seiten), Handbuch für Installation und Gebrauch (16 seiten), Gebrauchsanweisung (16 seiten), Gebrauchsanweisung (24 seiten), Gebrauchsanweisung (10 seiten), Gebrauchsanweisung (12 seiten), Gebrauchsanweisung (20 seiten), Gebrauchsanweisung (32 seiten), Installationsanleitung Handbuch (12 seiten), Handbuch (2 seiten), Kurzreferenz-Handbuch (2 seiten), Benutzerhandbuch (16 seiten), Gebrauchsanweisung (50 seiten), Informationen zur Verwendung (24 seiten), Gebrauchsanweisung (48 seiten), Informationen zur Verwendung (32 seiten), Informationen zur Verwendung (32 seiten), Benutzerhandbuch (32 seiten), Informationen zur Verwendung (32 seiten), Gebrauchsanweisung (24 seiten), Gebrauchsanweisung Handbuch (27 seiten), Benutzerhandbuch und Installationsanleitung (40 seiten), Informationen zur Verwendung (32 seiten), Gebrauchsanweisung (36 seiten), Benutzerhandbuch (24 seiten), Gebrauchsanweisung Handbuch (47 seiten), Benutzerhandbuch und Installationsanleitung (28 seiten)

Bosch Series 4 Gebrauchsanweisung

Trouble shooting

en
Lift the panel up and pull it out (fig. C).
4.
Clean the panels with glass cleaner and a soft cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Installation
During installation, make sure that the lettering "top
right" is upside down at the bottom left.
Insert the panel at an angle towards the back
1.
(fig. A).
Insert the top panel at an angle towards the back
2.
into the brackets. The smooth surface must face
outwards. (fig. B).
Put the cover back in
3.
place and press on it.
Attach the oven door.
4.
Do not use the oven again until the panels have been
correctly installed.
28
3Trouble shooting
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.

Rectifying faults yourself

You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 30
Fault
Possible
cause
The appliance is
Defective cir-
not working.
cuit breaker.
Power failure Check whether the kitchen light
The time is flash-
Power failure. Reset the time.
ing on the display.
The settings on
The child-
the appliance
proof lock is
cannot be config-
activated.
ured. A key sym-
bol has lit up on
the display or
†'""
.
Cleaning rec-
'–
appears on
ommenda-
the display.
tion.
The gas burner
Power cut or
does not ignite.
damp ignition
plugs.
--------
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Error messages on the display
If an error message with "
e.g.
-
, touch the
"ܠ
„ƒ
error message. Reset the time, if necessary.
If the fault was a one-off, you can continue to use your
appliance as normal. If the error message appears
again, call our after-sales service and quote the exact
error message and the E no. of your appliance.
~ "Customer service" on page 29
Notes/remedy
Check the circuit breaker in the
fuse box.
or other kitchen appliances are
working.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
Run the cleaning function in full.
The message can be dismissed
by pressing any button. It will con-
tinue to be displayed, however,
until the cleaning function has
been run in full.
Light the gas burner with a gas
lighter or a match.
" appears on the display,
"
button. This will reset the
v