Bose L1 Model II Benutzerhandbuch - Seite 26

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner Bose L1 Model II herunter. Bose L1 Model II 32 Seiten. Portable line array systems
Auch für Bose L1 Model II: Benutzerhandbuch (32 seiten), Benutzerhandbuch (28 seiten), Technisches Datenblatt (8 seiten), Technisches Datenblatt (8 seiten), Anwendungshandbuch (13 seiten), Handbuch (15 seiten)

PERATING

NSTRUCTIONS

Figure 8

Using a serial effects

connection

Using a serial effects connection with the L1 model I power stand

Note: Connecting an effects unit in serial requires a TRS split "insert" cable (with a ¼-inch TRS

connector on one side, and two mono ¼-inch phone connectors on the other). This type of cable

is readily available at most musical instrument stores and on the Internet.

1. Insert the TRS plug into the Channel 1 Insert jack on the L1 model I power stand.

2. Connect the ¼-inch mono plug (labeled "send", "ring", or "right") to the input of the

effects processor.

3. Connect the other ¼-inch mono plug (labeled "return", "tip", or "left") to the output of the

effects processor.

4. Adjust the effects level and mix of the effects processor.

Note: A very high output from the effects processor can overload the input of the L1 model I

power stand. If the LED on the remote turns red, even if the channel LEVEL control on the R1

remote control is below the 12 o'clock position, reduce the output level of your effects processor.

Note: The effects processor does interrupt the audio path. This may result in no audio output if

the effects processor is turned off. To use a "clean" signal, do not turn the effects processor off,

but put it in bypass mode.

Connect to

Channel 1 Insert

L1 model I power stand

TRS

TRS split "insert" cable

(Return, Left or Tip)

Connect to Effects Unit

OUTPUT

(Send, Right, or Ring)

Connect to Effect Unit INPUT

Digital Effects Unit