Atlas Copco TEX 12PSR Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Handbuch für Werkzeuge Atlas Copco TEX 12PSR herunter. Atlas Copco TEX 12PSR 20 Seiten.

Seite drucken

TEX 3, 05P, 09PS, 10PS, 12PS

Safety label

To avoid injury, before using or servicing tool, read

and understand separately provided safety

instructions.

Eject warning label

The label indicates that you must disconnect the

machine from the power source before removing or

changing the inserted tool.

Installation

Hoses and connections

Compressed air source

Water separator (optional)

Lubricator (optional)

Max. 3 meter compressed air hose between

the lubricator and the machine.

♦

Check that you are using the correct

recommended operating pressure, 6 bar (e).

♦

The maximum permissible air pressure, 7 bar (e),

must not be exceeded.

♦

Blow any impurities out of the compressed air hose

before connecting it to the machine.

Original instructions

Safety and operating instructions

Select the correct dimension and length for the

♦

compressed air hose. For hose lengths up to 30

meters, a hose with a minimum internal diameter

of 19 mm (3/4") should be used. If the hose length

is between 30 and 100 meters, a hose with a

minimum internal diameter of 25 mm (1") should

be used.

Methods to prevent freezing

Ice formation in the silencer can occur when the

ambient air temperature is 0–10°C (32-50 °F) and

the relative humidity is high.

The machine is designed to avoid the formation of

ice in the silencer. Despite this, under extreme

conditions ice can form in the silencer.

Take the following actions to further counteract the

risk of ice formation:

Use Atlas Copco Breaker and hammer AIR-OIL

♦

as a lubricant. Breaker and hammer AIR-OIL

counteracts freezing.

Use a water separator.

♦

Connecting a water separator

The length of the air hose between the compressor

and the water separator must be such that the water

vapor is cooled and condenses in the hose before

reaching the water separator.

If the ambient temperature is below 0 °C (32 °F) the

hose must be short enough to prevent the water from

freezing before reaching the water separator.

Lubrication

The lubricant is important for the machine's function

and has a great impact on the useful service life. If

there is no integrated lubricator, then connect a

separate lubricator to the air hose. To guarantee

good lubrication, the length of the air hose between

the separate lubricator and the pneumatic machine

should not exceed 3 meters.

Use a synthetic lubricant such as Atlas Copco

Breaker and hammer AIR-OIL or mineral oil with the

properties recommended in the table below.

Temperature

Lubricant

range (°C)

Breaker and

-30 to +50

hammer AIR-OIL

Mineral oil/Synthetic

+15 to +50

oil

Mineral oil/Synthetic

-20 to +15

oil

Viscosity

ISO VG 46–68

ISO VG 22–32