Bose FreeSpace E-4 Benutzerhandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Bose FreeSpace E-4 herunter. Bose FreeSpace E-4 19 Seiten. Business music system
Auch für Bose FreeSpace E-4: Benutzerhandbuch (18 seiten), Kurzanleitung für die Inbetriebnahme (4 seiten), Benutzerhandbuch (14 seiten), Benutzerhandbuch (15 seiten)
Seite drucken
8.2.3 Amplifier fault
The AMP OUTPUT LEDs work in pairs (1 and 2, 3 and 4) and indi-
cate the operating status of the four amplifier output channels.
AMP OUTPUTS
SYSTEM
STATUS
1
2
3
4
AUDIO SOURCES
DIRECT
INPUT
1
2
3
4
When an amplifier fault occurs, the amplifier mutes its outputs
and indicates an error. After a short period of time the amplifier
will try to operate again. If the fault condition persists, the ampli-
fier will attempt to restart six times, after which it will remain
muted.
Amplifier faults are typically caused by a shorted speaker line, an
overdriven amplifier, or a saturated output transformer.
• To check for a shorted speaker line, remove the speaker con-
nection from the amplifier channel. If this resolves the problem,
locate and correct the shorted loudspeaker line.
• To make sure that you are not overdriving the E-4 output,
change to a different source. If the problem no longer exists,
use the Installer™ software to reduce the input level of the
original source that was overdriving the output.
• To make sure an output transformer is not being saturated,
check to see if the correct speaker EQ setting is selected.
If none of these actions solve the problem, read the instructions
in the following flow chart or check the error log using the
Installer™ software.
8.0 E-4 System Troubleshooting
Check for
• Shorted wiring
• Overdriven amplifier
(reduce output gain)
• Transformer saturation
STANDBY
• Entry in Installer™ soft-
ware error log
AMP OUTPUT
indicators are red
Has the E-4 unit
shut down during
operation?
No
Is SYSTEM
STATUS indicator
green?
Yes
Does the Installer™
software Error Log list
any amplifier
faults?
No
Contact Bose
Customer Service.
62 of 76
• Check the number of loudspeak-
ers connected to the E-4 unit.
Verify that the total sum of loud-
Yes
speaker taps connected to the
E-4 unit does not exceed 400W.
• Verify that there are no shorts on
the speaker output lines.
• Switch POWER to OFF.
• Disconnect the load and switch
No
POWER to ON.
• Verify that there are no shorts on
the speaker output lines.
Yes
See amplifier fault troubleshooting
section for course of action.