Dromida DT4.18 BL Handbuch für Montage und Wartung - Seite 12
Blättern Sie online oder laden Sie pdf Handbuch für Montage und Wartung für Motorisiertes Spielzeugauto Dromida DT4.18 BL herunter. Dromida DT4.18 BL 13 Seiten.
Seite drucken
LED LIGHTS
Make sure when you plug your LED
lights into Channel 3 of the receiver.
On/Off
Switch
TUNING GUIDE
When tuning the Dromida DT4.18BL make sure that you have equal lengths from one side to the other on the
shocks and upper rods. Also, make sure to have the shock pre-load adjusters at the same setting from left to right.
They do not have to be the same front to rear.
PINIONS
The Dromida DT4.18BL comes stock with the 12 tooth pinion. To obtain higher top speeds you can install a larger
pinion gear onto the motor. This will, however, decrease your acceleration and run time. TIP: Smaller pinion equals
more torque, less top speed. Larger pinion equals more top speed, less torque.
SHOCK OIL
The Dromida DT4.18BL comes stock with 30 weight oil in the shocks. The handling can be tuned by changing the
shock oil to either heavier (bigger number) or lighter (smaller number). By putting heavier oil in the shocks, the
car will have less chassis roll and become more responsive. Putting lighter oil in the shocks will cause the car to
be less responsive and have more chassis roll. For smooth, high traction surfaces, a thicker oil would be best. For
low traction or bumpy surfaces, a lighter oil would be best.
CAMBER
Camber refers to the angle at which the tire and wheel ride
in relation to the ground when viewed from the front or rear.
Negative camber is when the wheels lean inward and positive
camber is when the wheels lean outward. Usually adding
a small amount of negative camber (0° to -2°) will increase
traction. However, adding too much camber will decrease
traction. The objective is to keep as much of the tire as possible
in contact with the running surface. Never put in positive
camber. Make sure that both sides are equal.
SHOCK SPRINGS
For low traction or bumpy surfaces, a softer spring should be used. For high traction or smooth surfaces, a fi rmer
spring should be used.
FRONT SHOCK ADJUSTMENT
Moving the tops of the shocks out (A) will increase steering
reaction but decrease front traction. Moving the tops of the
shocks in (B) will result in slower steering reaction but will be
smoother over bumps and have more front traction.
REAR SHOCK ADJUSTMENT
Moving the tops of the shocks out (A) will increase steering
reaction and decrease rear traction. Moving the tops of the
shocks in (B) will result in slower steering reaction but will be
smoother over bumps and have more rear traction.
STEERING
ESC
LIGHTS
To turn the LED lights on, switch the on/off switch to the on
position. To make sure you do not leave your Dromida LED
lights on when not running your kit, you should dissconnect
the battery after every run.
DIDC0056 v1.0 © 2015 DROMIDA, A HOBBICO COMPANY
We try very hard to have accurate and up-to-date information in this document. Any errors are unintentional.
2˚ NEGATIVE CAMBER
ADJUST LENGTH TO
CHANGE THE CAMBER
A
A
B
B
A
dromida.com