Elektor TAPIR Bauanleitung - Seite 2
Blättern Sie online oder laden Sie pdf Bauanleitung für Sicherheitssensoren Elektor TAPIR herunter. Elektor TAPIR 9 Seiten. E-smog detector kit
Auch für Elektor TAPIR: Bauanleitung (15 seiten)
Seite druckenThe following components should be present in the kit:
-
1 PCB panel
-
1 headset (ear buds)
-
1 plastic bag with all electronic components
-
1 length of wire (approximately 40 cm)
The plastic bag should contain the following items:
-
2 small bags with small parts
-
1 coil
-
2 Cinch plugs
-
1 Cinch panel-mount connector
The small bags should contain the following components:
Bag 1:
-
1 resistor 1 k
-
2 resistors 10 k
-
1 transistor BSR17 (T1)
-
2 transistors BC847B (T2, T3)
-
1 capacitor 10 nF (C1)
-
2 standoffs M2x6
-
2 screws M2x6
Bag 2:
-
2 resistors 100 k
-
3 capacitors 10 F (C2, C3, C4)
-
1 diode BAT54S (D1)
-
1 switch
-
1 3.5 mm audio jack
-
1 spring for battery
The following items are required for the proper assembly of this kit:
- A well lit and tidy work surface
- The TAPIR kit
- A soldering iron or soldering station with a fine tip
- Tweezers for placing small SMDs on the board
- Resin-core solder with a maximum diameter of 0.5 mm (0.02 inch)
- A small drill bit for countersinking the cover screws
- One AAA battery
- A length of heat-shrink tubing or electrical tape
- If necessary, a magnifying glass for checking
component markings and solder joints
- A coping saw and a file or Dremel tool as necessary
- Clamping tweezers as necessary
Kit Contents
(R5)
(R2, R3)
(R1, R4)
Required Items
2