3M PELTOR WS LiteCom Plus Technisches Datenblatt - Seite 3

Blättern Sie online oder laden Sie pdf Technisches Datenblatt für Kopfhörer 3M PELTOR WS LiteCom Plus herunter. 3M PELTOR WS LiteCom Plus 7 Seiten. Headset
Auch für 3M PELTOR WS LiteCom Plus: Kurzanleitung (3 seiten)

Seite drucken

3M PELTOR WS LiteCom Plus Technisches Datenblatt

Fitting Instructions

Inspect the hearing protector before each use. If damaged,

select an undamaged hearing protector or avoid the noisy

environment.

When additional personal protective equipment is necessary

(e.g. safety glasses, respirators, etc.), select flexible, low

profile temples or straps to minimize interference with the

earmuff cushion. Remove all other unnecessary articles (e.g.

hair, hats, jewelry, headphones, hygiene covers, etc.) that

could interfere with the seal of the earmuff cushion and

reduce the protection of the earmuff.

Headband Headset

To fit the hearing protector:

1. Slide out the cups and tilt the top of the cup out, as the

cable must be on the outside of the headband (Fig 1).

2. Pull the cups apart and place the earmuffs over the ears

so that the cushions form a snug seal around the ears.

3. Adjust the height of the cups by sliding them up or down

while holding the headband in place (Fig 2).

4. The headband should be positioned across the top of

your head (Fig 3).

Neckband Headset

To fit the hearing protector:

1. Place the cups in position over the ears (Fig 1).

2. Keep the cups in position, place the head strap on top of

your head and lock it tight in position (Fig 2).

3. The head strap should be positioned across the top of

your head and should support the weight of the headset

(Fig 3).

Caution: The neckband earmuffs must be worn with

the head strap correctly attached to keep them firmly

in position to maintain an effective acoustic seal. The

protection level provided by neckband earmuffs may be

reduced if the head straps are not worn correctly.

Helmet Attach Headset

To fit the hearing protector:

• Fit the cup: Push the attachment blade firmly into the slot

on the side of the helmet until it clicks into place (Fig 1 & 2)

• Working position: With the cups over the ears press the

arms inwards until you hear a click on both sides indicating

a firm seal (Fig 3).

• Stand-by position: Lift the cups to the fixed stand-by

position. In a noisy environment the ear muffs must be

worn in the working position at all times (Fig 4).

• Parking position: First lift the cups to the stand-by position

(Fig 4), then rotate them up to the next fixed position.

• Ventilation mode: Avoid placing the cups against the

helmet as this prevents ventilation (Fig 5).

• Storage mode: When the helmet is not in use, lower the

earmuffs and press them inward. Keep the cups clean and

dry and store at normal room temperature.