ELEKTRA S1CB Chrome Schulungshandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Schulungshandbuch für Kaffeemaschine ELEKTRA S1CB Chrome herunter. ELEKTRA S1CB Chrome 6 Seiten.
6.MAKING COFFEE
3.
Wipe
off
excess
coffee
grounds from the rim of the
filter basket.
4.
Fit the coffee handle securely
into group head – to ensure
it does not release during
coffee extraction. Make sure
the coffee handle is properly
Make sure the coffee handle is securely fitted
locked into position by moving
it to the right to give a tight fit.
Otherwise the handle can
twist and release during coffee
extraction.
5.
Place coffee cup(s) onto drip
tray.
6.
Place one hand on the base
of the machine to secure it.
7.
Hold the lever with the other
hand, keeping your elbow
above the lever.
Hold machine base and always keep elbow
8.
Push the lever down in a single
above pump lever
motion while standing over
the machine and keeping your
elbow above the lever at all
times. You'll hear and feel
water entering the group head
chamber.
9.
Hold the lever in this position
until coffee begins to drip
through.
10.
Release the lever which will
Lever in fully lowered position. Hold until
coffee strarts dripping
slowly return to the upright
position.
13.
Dump the used coffee cake
into dumping box or by
11.
For more coffee, pull the lever
tapping the coffee handle
down once more. Wait for
coffee to drip and release
on a non-metal surface.
lever. The second extraction of
coffee will flow more quickly.
14.
Rinse the handle/basket
and return to the group head.
12.
When the lever is fully raised,
remove the coffee handle by
Note:
slowly and carefully pulling it
horizontally to the left until a
•
It normally takes 25–30
pressure releasing hiss is
seconds to extract a shot
heard. Allow the pressure to
of coffee.
slowly release to avoid splat-
tering the coffee grounds.
•
Around 30ml of coffee
is extracted per cycle
of the pump lever.
08
7.FROTHING OR HEATING MILK
You can froth or heat milk while
coffee is being extracted.
To do this:
1.
Purge the steam wand of con-
densation by releasing steam
into a container.
2.
Fill a stainless steel jug with
the required amount of milk.
Avoid filling jug much more
than half way.
3.
Immerse the tip of the steam
wand into the centre of the
jug, just below the surface of
the milk.
4.
Turn on the steam tap until you
hear a soft "psst-psst" sound,
which indicates the milk is
being frothed. As the milk level
rises, lower the jug to ensure
the wand stays just under the
surface of the milk to maintain
the "psst-psst" sound.
Refilling the boiler
1.
When the boiler level is less
than a quarter full, turn off the
machine. Then open the steam
tap and allow all the boiler
steam to release into a jug or
suitable container.
2.
Remove the boiler cover. Use a
cloth, as the cover will be hot.
3.
Carefully undo the boiler plug
(it could be hot!), and refill the
boiler. Replace the boiler plug
and boiler cover and turn on
the machine. It should be
ready to make coffee in
around five minutes.
8.MAINTENANCE AND CLEANING
Daily
1.
Use a clean sponge, cloth or brush
to clean the shower head and
up inside the group head.
2.
Place a cup onto drip tray
and push the pump lever
down to flush a small amount
of water through the group
head.
09
5.
When the milk is sufficiently
frothed, lower the steam wand
into the milk to heat it.
Move the wand around the
milk to ensure even heating.
Do not boil the milk!
Correct temperature can be
judged by holding your hand
against the jug. When the
temperature is too hot to the
touch, wait four seconds or so,
then turn off the steam.
6.
Remove the jug and immedi-
ately release a small amount
of steam into a container to
flush any milk deposits from
the tip of the wand. Otherwise,
the milk will dry, possibly
blocking the wand and caus-
ing a health hazard. Also wipe
the steam wand with a clean
damp cloth to remove any milk
before it dries.
Turn steam tap on (as shown) and release
boiler pressure until gauge shows 0
3.
Place a small jug of cold water
under the steam wand and
release steam to remove any
milk deposits from the wand.
4.
Wipe the surface of the wand
with a soft damp cloth, includ-
ing all grooves or places where
milk could build up.