anko JK-145 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kessel anko JK-145 herunter. anko JK-145 7 Seiten.

USING YOUR ELECTRIC KETTLE

Place the kettle on a flat surface.

2. To fill the kettle, remove it from the power base and open the lid by pressing down on the lid

release button, then fill the kettle with the desired amount of water and close the lid. The water

level must be within the Min. (1.0L) and the Max. (1.7L) level marks. Too little water will cause the

kettle to switch OFF before the water has fully boiled.

NOTE: Do not fill the water over the Max. level mark, as water may spill out of the spout when

boiling. Ensure that the lid is firmly in place before connecting to mains power.

3. Position the kettle on the power base.

4. Connect the supply cord plug into a mains power outlet. Press down the power switch on the

kettle, the indicator will light up showing the kettle is operational.

5. When the water has reached the desired temperature, the kettle will switch off automatically.

You can stop the boiling at any time by lifting the switch up.

6. The kettle may now be safely removed from its base and the boiled water poured out.

7. To re-boil, depress the switch again. If the water is very hot, it may be necessary to wait

approximately 30 seconds until the switch resets.

8. Always ensure the lid is tightly fitted and never lift the kettle while it is boiling or you run the risk

of scalding.

NOTE: Ensure the switch is free of obstructions and the lid is firmly closed. The kettle will

not turn OFF automatically if the switch is constrained or if the lid is open.

CAUTION: Be careful when pouring the water from your kettle as boiling water may result

in scalding. Do not open the lid while the water in the kettle is hot.

9. The kettle may be stored on the power base when not in use.

NOTE: Always disconnect from mains power outlet when not in use or when storing.

The kettle is fitted with a safety device which switches the kettle OFF if the appliance is operated

with insufficient water or without water. If this occurs, the kettle should be disconnected from

mains power supply and allow the kettle to cool thoroughly before refilling with cold water.