anko BL1015-GS Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Blender anko BL1015-GS herunter. anko BL1015-GS 12 Seiten.

3. Connect the appliance to mains power, and then push the power switch to "ON" position.

4. Turn the speed dial to the "HI" speed setting and the appliance will start to blend.

5. After blending for about 30 seconds, turn the speed dial to "STOP" position.

6. You may add ingredients into the jar through the center opening of jar cover during operation.

First, turn OFF the appliance to make it stop working, and then remove the measuring cup and

add the ingredients into the jar through the center opening on the jar. Replace the measuring

cup into position. Then turn ON the appliance.

NOTE:

1) During operation, if the mixture is too thick to be blended, use the tamper (refer to

"Tamper" description mentioned above).

2) DO NOT remove the jar from the motor unit during use. If it is necessary to remove the jar,

first turn OFF the appliance and make sure the blender blade has stopped rotating. Then remove

the jar.

3) The maximum operating time per cycle must not exceed 3 minutes. Allow minimum 10

minutes rest time between two consecutive cycles to prevent damage to the electric motor. The

appliance must rest for at least 30 minutes after 10 cycles.

4. After finish blending, move the jar out of the jar support pad, and then carefully remove the

measuring cup and jar lid, then pour and serve.

CAUTION: The speed dial and power switch must be at "STOP" and "OFF" positions

and the power supply cord must be disconnected from mains power outlet before

removing the jar.