ANLIDAR MyTorq MY8-EP0103L Handbuch für Betrieb und Wartung - Seite 10
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Kraftschraubendreher ANLIDAR MyTorq MY8-EP0103L herunter. ANLIDAR MyTorq MY8-EP0103L 13 Seiten. Dc-type automatic non-carbon-brush with counter series
※There is a new judgment which is the screwdriver will judge a N.G.in the case of there is a start signal and it is OFF before Lt.
Push both UP + DOWN set up the buzzer:
ON
Fastening a screw, completing work and mistaken operation, buzzer will be on.
OFF
Wrong operation will be buzzed.
FF
Work completed and wrong operation will cause buzz.
As one screw is fastened and work is completed, buzzer will be on; as mistake made has no buzz.
EF
Ht/Lt Description:
Ht/Lt mainly set up the period of time. If stop is within the set period, it means OK. In contrast, it will be (NG), as stop
before Lt or after Ht. and should reconfirm whether wrong screws is taken. More accuracy requested means more
correct Ht/Lt set-up should be. The LT accepts 0.00, but it can be increased or decreased in SELECT.
START
N.G
If screwdriver stops before Lt.
Screws stuck or wrong screws
※To shut down the count: If count needs be shut down, push P key for five seconds until no figures on the panel, meanwhile
LED 1 will show green light.
※If set value need be reset during counting, just push three seconds.
※Simulate-learning: as electric screwdriver is not used, push S key and then push P key to enter simulate-learning procedure;
SL(S)===SC(S)===At(S)=== Test Data===(P)
1) Show SL (Screw List), select UP/DOWN to change number and then push S(confirm)
2) Show SC (counting number), select UP/DOWN to change number and then push S(confirm)
3) Show At (automatic zero), UP/DOWN to change value; then push P (confirm)
4) Enter simulate-learning (LED 1 will keep flash)
5) When recording value, push P key and back working condition.
※LED light flash in simulate-learning.( means under simulate- learning condition), push P key to record value after simulate -learning. )
※As no use of screwdrivers: UP and push P key can set up waiting time.
If three seconds are set, but no starting signal after set time, it will buzz.
open collector contact
(2) OK ONE
(1) GND
OK
Lt
0.02 s
It is "OK" as
screwdriver stops
between Lt and Ht.
NO. Function
1
GND
2
OK ONE
3
N.G
4
OK All
(4) OK All
(1) GND
STOP
Ht
2.0 s
If screwdriver has no stop after Ht.
Screws stripped or wrong screws
9
Color
Black
Brown
Red
Orange
(3) N.G
(1) GND
N.G