ANLIDAR MYTORQ MYAC51-0212P Handbuch für Betrieb und Wartung - Seite 7
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Kraftschraubendreher ANLIDAR MYTORQ MYAC51-0212P herunter. ANLIDAR MYTORQ MYAC51-0212P 11 Seiten.
Seite drucken(1). Forward/Reverse Switch : To switch screwdriver run in Reserve or Forward
R : Run in reserve to untighten screw。
F : Run in Froward to tighten screw。
(2). L-TYPE: Press Level switch and hold to start screwdriver, release to stop。
P-TYPE: Under Pressure and hold to start screwdriver, release to stop。
(3). Front Locking Ring : To fixed the housing of screwdriver。
(4). Torque Adjusting Ring : To adjust torque from low (scale 0) to high (scale 8) torque。
(5). Bit holder cap : Pull out to put bit into the holder or take out from the holder。
Attaching / detaching bit and bit type
Push up the holder clamp by finger tip, and it will be unlocked. Thus, the bit can be freely attached and detached (single finger
notion type) select such a bit whose shank is equal to the size shown below.
Insert the power plug into a receptacle and set the changeover switch to "F" position.
Apply the bit to the screw head and press the lever or push main body to, then the switch will be turned ON to start the motor
running.
When the screw is tighten and reach the torque that you had set, The tool will stopped automatically.
To reset the tool by releasing the lever to the original position or releasing the bit From the screw head.
To return the screw, set the changeover switch to "R" position.
Function Discription
(2)
L-TYPE
(3)
(5)
Description of Operation
(1)
P-TYPE
(3)
(4)
(5)
6
(1)
Under Pressure
(2)
(4)