AIRTEQ 9912S Handbuch - Seite 17

Blättern Sie online oder laden Sie pdf Handbuch für Schlösser AIRTEQ 9912S herunter. AIRTEQ 9912S 18 Seiten.

3. Motor or Solenoid Position

i. Verify when motor or solenoid activate that latch bolt pulls back completely

a. Adjust Motor/Solenoid position down if latch bolt doesn't pull back far

ii. Verify when motor or solenoid returns to locked position that the latch bolt is

completely out, and the actuator can rotate into the deadlock position

a. Adjust Motor/Solenoid position up if actuator is restrained from rotating into

C. Electrical

1. The electrical actuation system of this lock is

designed for 120 VAC. Any other voltage is not

acceptable.

2. Deadlock status switch function must be

checked during regular lock maintenance/

lubrication.

i. VERIFY CORRECT MECHANICAL

DEADLOCKING OPERATION FIRST

(Steps B.1 and B.2 above)

ii. With lock deadlocked, the DL switch arm

should activate the switch.

a. Via multi-meter, there SHOULD be continuity between switch COM & NO terminals

b. Via multi-meter, there SHOULD NOT be continuity between switch COM & NC

terminals

iii. With lock NOT deadlocked, the DL switch arm should NOT be activating the switch.

a. Via multi-meter, there SHOULD be continuity between switch COM & NC terminals

b. Via multi-meter, there SHOULD NOT be continuity between switch COM & NO

terminals

iv. If the switch arm is not correctly positioned to actuate the switch during mechanical

deadlock, and to release the switch when NOT mechanically deadlocked, adjust/slightly

bend the switch arm.

v. If the switch does not switch and/or release correctly even with proper switch arm

adjustment, replace the switch

vi. NOTE: THE SWITCH MUST REGISTER NOT DEADLOCKED (Step C.2.iii) IN ANY CASE

WHERE THE LOCK IS NOT MECHANICALLY DEADLOCKED. If the lock installation/door

position/door gap does not press the deadlatch sufficiently to activate the lock's

mechanical deadlocking function, correct the mechanical position of the door/lock until

complete mechanical deadlocking is accomplished. DO NOT ADJUST THE DEADLOCK

STATUS SWITCH TO INDICATE A DEADLOCK CONDITION WHEN THE LOCK IS NOT

MECHANICALLY DEADLOCKED.

enough

the deadlock position