DRY AGER DX 1000 Betriebsanleitung - Seite 10
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Netzwerk-Hardware DRY AGER DX 1000 herunter. DRY AGER DX 1000 17 Seiten.
Auch für DRY AGER DX 1000: Benutzerhandbuch (14 seiten)
Seite drucken
- 1. Disposal Notes
- 2. Saving Energy
- 3. Description of the Appliance
- 4. Integrated Systems
- 5. Safety Instructions and Warnings
- 6. Electrical Connection
- 7. Interior Light
- 8. Safety Lock
- 9. Display and Symbols
- 10. Key Combination
- 11. Error Messages
- 12. Alarm Acknowledgement
- 13. Changing over Door Hinges
- 14. Shutting Your Appliance down
Air exchange with activated charcoal filter
We recommend that you replace the filter once a year. Filters can
be obtained from your dealer.
Changing the filter:
Take the filter by the handle.
Turn it 90° to the left or right
and remove.
Inserting the filter:
Insert with the handle in a
vertical position. Turn it 90° to
the left or right until it clicks
into place.
Cleaning
Before cleaning always switch off the appliance. Pull out the
mains plug or remove/unscrew the fuse.
• Clean the inside and outer walls with lukewarm water and a
little detergent. Do not use abrasive or acid cleaners or
chemical
solvents.
• Use a glass cleaner to clean the glass surfaces and a
commercially available stainless-steel cleaning agent for the
stainless-steel surfaces.
Do not use steam cleaners because of the
risk of injury and damage.
• Ensure that no cleaning water penetrates into the electrical
components or ventilation grill.
• Do not damage or remove the type plate on the inside of the
appliance. It is very important for servicing purposes.
10
Malfunctions
You may be able to rectify the following faults by checking the
possible causes yourself.
• Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the fuse intact?
• Loud running noise:
– Is the appliance set up firmly on the floor?
– Does the appliance cause nearby items of furniture or objects
to vibrate? Please note that noises caused by the refrigerant
circuit cannot be avoided.
• The temperature is not low enough:
– Is the temperature setting correct (see "Setting the
temperature")?
– Does the separately installed thermometer show the correct
reading?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes apply and you cannot rectify
the fault yourself, contact the nearest
customer service department
stating the type designation
service number
and appliance
number
as indicated on the
type plate.
The position of the type plate
is shown in the section entitled
Description of the appliance.
,