DryAIR HRA 4000 Benutzerhandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Werkzeuge DryAIR HRA 4000 herunter. DryAIR HRA 4000 15 Seiten.

Gear Box

Maintenance & Operation

*CAUTION! Oil, housing, and other components can reach high temperatures during operation, and can cause

severe burns. Use extreme care when removing lubrication plugs and vents while servicing the unit. *

• Do not operate the unit without making sure it contains the correct amount of oil. Do not

overfill or under fill with oil, or injury to personnel, unit, or other equipment may result.

• For proper operation in subzero conditions, it is mandatory that the following oil be used:

"Spartan EP 320 industrial gear oil" (or equivalent)

...any other gear oil will void warranty!

•

Remove Fill and Vent plugs (see Figure 3-1 for locations).

•

Clean threads on the removed plugs and the plug holes with degreaser.

•

Fill gear box with the recommended lubricant (see above) to a level near the center line of the

uppermost horizontal shaft or until lubricant comes out of the oil level plug hole.

•

Install plugs secure in gear case.

After the first 100 hours of operation, drain out initial oil, flush out the gear case with an approved non-

flammable, non-toxic solvent, such as Whitmore's Flushing Oil (#06802030) or Medallion Flushing Oil

Kosher (#06812010), and refill. Thereafter, oil should be changed at least every 2500 operating hours or

every 6 months - whichever occurs first.

*Note: Oil should be changed with greater frequency if unit is used in severe environments (dust or high

humidity). *

• Although the torque limiter clutch is factory (Dryair) set, periodic adjustment may be required. It is

recommended that the torque setting of the clutch be checked twice a season. With prolonged use,

the two friction disks, located on either side of the A-plate sprocket, will eventually show wear.

• It is important that the torque limiter clutch is adjusted properly. If the clutch slips too easily, the

spool will take too long to stop and hose will pile up on the reel. If the clutch does not slip at all,

Maintenance

Figure 3-1: Gear Box Oil Filling Procedure

3-2