Daikin FXMQ200NFRV16 Betriebshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Fan Daikin FXMQ200NFRV16 herunter. Daikin FXMQ200NFRV16 16 Seiten. Air processing unit

Seite drucken
Do not block
air inlets or outlets.
Impaired airflow may result in insufficient performance or
trouble.
Do not use the air conditioner for purposes other than
those for which it is intended.
Do not use the air conditioner for cooling precision instru-
ments, food, plants, animals or works of art as this may
adversely affect the performance, quality and/or longevity
of the object concerned.
Do not install the air conditioner at any place where
there is a danger of flammable gas leakage.
In the event of a gas leakage, build-up of gas near the air
conditioner may result in a fire.
Carry out drain piping properly to ensure complete
drainage.
If drain piping is not carried out properly, drain will not flow
out. Then, dirt and debris may be accumulated in the drain
piping and may cause water leakage. If it occurs, stop the
air conditioner and call your local dealer for assistance.
NOTE TO SERVICE PERSONNEL
WARNING
• Before inspection (of the electrical parts box,
fan motor, auxiliary electric heater, drain
pump etc.) ensure the power to the air-condi-
tioner and auxiliary heater is disconnected to
avoid electric shock.
• When cleaning the heat exchanger, remove
the electrical parts box, fan motor, auxiliary
electric heater and drain pump.
Water or detergent may deteriorate the insula-
tion of the electrical components, resulting in
component failure.
CAUTION
• Removing the panel.
WATER SUPPLY PORT
• See below and remove the appropriate panel
depending on the purpose of the work to be
done.
The purpose of the work
to be done
To check the electrical
parts of the heat
exchanger.
To service the fan assy. Bottom Panel
To check the drainage.
To clean the drain pan.
ELECTRICAL
BOTTOM PANEL
Panel
Panel B+A
Pa
B
Panel A +
* Do not remove the panel except when necessary.
* Do not remove the panel on the opposite side to
this one.
2. OUTDOOR-AIR PROCESSING
UNIT : NAME OF EACH PART
(Refer to figure 1)
Air outlet
Remote controller
Air filter
Ground wire
Electric parts box
Outdoor air inlet
Refrigerant pipe and interconnecting wire
Power wire
Drain pipe
Heat exchanger
Fan
Drain pump kit (Optional accessory)
3. REMOTE CONTROLLER :
NAME AND FUNCTION OF EACH
SWITCH AND DISPLAY
(Refer to figure 2)
1. On/off button
Press the button and the system will start. Press
the button again and the system will stop.
2. Operation lamp (red)
The lamp lights up during operation.
3. Display "
"
(changeover under control)
It is impossible to change heat/cool with the
remote controller when this icon is displayed.
4. Display "
" "
" "
This display shows the current operation mode.
5. Display "
" (programmed time)
This display shows the programmed time of the
system start or stop.
6. Display "
" (inspection/test operation)
TEST
When the inspection/test operation button is
pressed, the display shows the mode in which
the system actually is.
7. Display "
" (under centralized control)
When this display shows, the system is under
centralized control.
(This is not a standard specification.)
" (operation mode)
" "