Daikin MC707VM-S Betriebshandbuch - Seite 17

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Luftreiniger Daikin MC707VM-S herunter. Daikin MC707VM-S 19 Seiten. Photocatalytic
Auch für Daikin MC707VM-S: Betriebshandbuch (19 seiten), Betriebshandbuch (19 seiten)

Seite drucken

Question

Can I wash the

deodorization catalytic unit?

Is replacement necessary?

wires are cut?

while the cleaning sign is

Case

The cleaning sign does not turn

This is due to dusts built up in the dust sensor.

Vacuum dusts from the air inlet with a crevice nozzle of a cleaner and then manually operate the unit for

a while. The sensor will go back to normal.

This is because react time of the dust sensor differs depending on the size of room.

If the unit is installed at the lower position of a room, reaction to smoke of cigarettes or others may be

bad. Re-install the unit at the higher place such as on a shelf. If the sensitivity is still bad, adjust the

sensor with sensitivity settings.

The deodorization catalytic unit cannot be washed.

(The unit will be ruined.)

Vacuum dusts with a cleaner without removing from the main unit. Replacement is not necessary.

If the ionizer wires should be cut, replacement is necessary.

Contact your dealer.

While the cleaning sign is blinking, electric dust collection and deodorization functions remarkably

deteriorate as electricity supply to the ionizer wires and streamer discharger stops for safety.

Be sure to inspect inside until the sign turns off.

(Blinking is not a problem from a safety viewpoint.)

Is the power plug unplugged?

Is the front panel correctly set?

Are the battery of the remote controller dead?

ontroller dead?

Is there any foreign matter in the air outlet?

r in the air outlet?

n the air outlet?

Is the unit installed at a location where the

talled at a locatio

talled at a loca

flow does not pass or are there obstructions

not pass or are t

ot pass or are t

close to the unit?

the unit?

Is there too much dust in the pre-filter or

here too much du

ere too much du

pleated filter?

leated filter?

d filter?

Is too much od

Is too much odors or smoke being generated?

s too much o

Is a television or radio installed within 2m of

Is a televis

a te

this unit or is an indoor antenna being used

is unit

close to this unit?

Is the power cord or antenna of the television

or radio close to this unit?

Is the plasma ionizer securely set?

Is dust adhering to the ionizing line of the

plasma ionizer (resin part)?

Has water entered into the spurt hole

moistening the negative ionization assembly?

Is a large amount of odor being generated

temporarily? (Many people smoking or

grilling meat.)

Have you moved the main unit to another room?

If the pre-filter or plasma ionizer dirty?

Is the plasma ionizer set securely?

Are not droplets left in the opposing pole

plates or other places?

Are not bits of tissue left in the plasma ionizer?

Did you rinse and soak the plasma ionizer

well after washing the plasma ionizer with

detergent?

Are not the ionizer wires cut?

Answer

Secu

Securely

Securely insert it.

Securely set it.

cur

oller dead?

Replace with new battery. (page 5.)

Remove the foreign matter.

For other cases, contact your dealer.

Remove the obstruction.

Clean or replace. (pages 5, 6, 9)

For this case, contact your dealer.

Separate the television, radio and indoor antenna from

this unit by 2m or more.

Separate the power cord and antenna of the television

or radio as much as possible away from this unit.

Securely set it.

Clean the plasma ionizer. (pages 11, 12.)

If the negative ionization assembly is dry, the sound will

go away.

If operated, the odor will gradually go away.

Odor from the original room may smell.

Clean it. (pages 9, 11, 12, 13.)

Securely set it.

Wipe off droplets.

Remove bits of tissue.

Soak well.

Contact your dealer.

rization funct

on func

discharger stops f

harger stop

Measure

English /