Anova CC400P Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Rasenmäher Anova CC400P herunter. Anova CC400P 14 Seiten.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methan can attract moisture which

eads to separation and formation of acids during storage.Acidic gas can damage the fuel system of an

engine while in storage.To avoid engine problems, the fuel system should be emptied before storage of 30

days or longer. Empty the gas tank , start the engine and let it run until the fuel lines and carburetor are

empty. Use fresh fuel next season. See Storage Instructions for additional information . Never use engine

or carburetor cleaner products in the fuel tank or permanent damage may occur.

START ENGINE

To start the engine, first make sure that the spark plug and that the machine is filled with sufficient oil and

petrol.

NOTE: Due to protective coating on the engine, a small amount of smoke may be present during the

initial use of the product and should be considered normal. Hold operator presence control bar down to the

handle and pull starter handle quickly.Do not allow starter rope to snap back.

NOTE: In cold condition, it's necessary to push the primer button on the air filter before pulling the

starter coil, (Please see form 1).

We aslo should put more fuel to mix with air for easy start. When you push the primer button, it will pump

the fuel direct from carburetor to burning housing.

NOTE: In cold condition it may be necessary to repeat priming steps.

STOP ENGINE



To stop engine, release operator presence control bar.



WARNING! The blade will continue to rotate for a few seconds after the engine has stopped.

Disconnect the spark plug cap if the lawnmower is to be left unattended.

MOWING TIPS



Under certain conditions, such as very tall grass, it may be necessary to raise the height of cut to

reduce pushing effort and to keep from overloading the engine and leaving clumps of grass

clippings.It may aslo be necessary to reduce ground speed and/or run the lawn mower over the area a

second time.



For extremely heavy cutting, reduce the width of cut by over lapping previously cut path and mow

slowly.



Pores in cloth grass catchers can become filled with dirt and dust with use and catchers will collect

less grass. To prevent this, regularly hose catcher off with water and let dry before using.

Primer only for cool engine use

Temperature

<0℃

0℃~10℃

>10℃

Fom 1

Push time

2~3

1~2

0~1