Anova TPB3003 Benutzerhandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Rasen- und Gartengeräte Anova TPB3003 herunter. Anova TPB3003 11 Seiten. Battery pruning scissors
Seite drucken4. Maintenance
4.1 Scissor maintenance
1. Do not cut branches outside the cutting range; do not cut non-plant materials, such as metals and
stones, etc. do not use clamps or the like to hold the scissors; Always replace the cutting blade, if it is
worn or damaged.
2. Keep the cutting equipment clean, wipe the scissors, batteries, and charger with a clean cloth (do not
use corrosive detergents!) And a soft brush or dry cloth to remove dust from the upper scissors.
3. Do not immerse the scissors, batteries, and charger in water or other liquids;
4. Use the equipment correctly; stop using it when there is damage to the scissors, batteries and / or
chargers.
5. If the switch cannot turn the scissors on or off, do not use the scissors. It will be dangerous to control
the scissor without the switch properly. Replace and repair the switch in this case always before using
the scissors again.
6. Make sure the switch keeps the shears off when replacing accessories or storing the pruning shears.
Such a preventive measure will reduce the risk of accidentally activating the scissors and injuring the
user.
7. Turn off the pruning shears if you are not going to use it and store it out of the reach of children. It is
dangerous to allow inexperienced persons and untrained users to operate the pruning shears.
8. When using pruning shears, respect the tool and the specific use for which it was designed. Consider
the work environment and the tasks to be performed; You can cause risk and damage by using pruning
shears that are not working properly.
9. After use, remove the dirt from the movable knife and supporting knife, add lubricating oil or motor oil
on the contact part, keep the knife in good sharpening condition to extend its service life and to
upcoming uses.
4.2 Battery maintenance
1. Use the battery as the only valid power source for your electric pruning shears. Do not use the
battery as a power source for any other power tool not listed.
2. Do not charge the battery in temperatures below 0ºC or above 45ºC; this can damage the battery
and charger.
3. Make sure the battery switch is off before connecting the power cord; if it is open it can create a
problem when connecting to the scissors.
4. Use only the charger assigned by the manufacturer to charge the battery; You can cause a battery
fire or explosion if you use chargers with inadequate power.
5. When the battery is not in use, be sure to keep it away from metal objects such as paper clips,
coins, keys, screws, etc. that can shorten the battery charge or cause unintentional discharge or fire
hazard.
6. Do not disassemble or rebuild the battery.
7. Do not use damaged or short-circuited batteries.
8. Do not place the battery on hot surfaces or sources of heat; do not expose it directly to the sun.
9. Do not place the battery near fire or in contact with water.
10. Do not charge the battery near fire or in direct sunlight.
11. Do not drive nails or other objects into the battery; do not hit it with hammers or trample on it, and do
not throw the battery on the ground hastily.
12. Do not use damaged or deformed batteries.
13. Do not solder batteries directly.