Anprobe BT-120 Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Prüfgeräte Anprobe BT-120 herunter. Anprobe BT-120 12 Seiten. Breaker tracer

BATTERY REPLACEMENT

Power is supplied by 9V Alkaline Battery x1

The Identification Arrow LED on the receiver will not turn ON when

replacement is needed. To replace the battery, remove the screw from the back

of the meter and slide the battery door outward. Remove the battery from

case bottom and replace it with a fresh 9V Alkaline battery.

If there appears to be a malfunction during the operation of the meter, the

following steps should be performed in order to isolate the cause of the

problem.

1. Check the battery. Replace the battery immediately when the receiver

LED doesn't turn ON.

2. Review the operating instructions for possible mistakes in operating

procedure.

Except for the replacement of the battery, repair of the meter should be

performed only by a Factory Authorized Service Center or by other qualified

instrument service personnel. The front panel and case can be cleaned with

a mild solution of detergent and water. Apply sparingly with a soft cloth and

allow to dry completely before using. Do not use aromatic hydrocarbons or

chlorinated solvents for cleaning.