FourStar FIB-IE-M Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Adapter FourStar FIB-IE-M herunter. FourStar FIB-IE-M 12 Seiten. Industrial ethernet optical fiber link adapter
Seite drucken● LED indicator
LED indicator
PWR
LFP
TP-SPD
TP-FDX/Col
TP-Link/Act
FX-Link/Act
● Link Fault Pass Switch:
Switch position
LFP_ON
LFP_OFF
Note: after turning the switch, the new settings will not take effect until power on again.
4. User Guide
Before installing the Ethernet optical fiber link adapter, please confirm that the connected
network cable (Cat. 5 twisted pair) can not exceed 100m in length and the maximum length of the
optical fiber cannot exceed that specified by the user manual, which is 5km in multimode and 20km
in single mode.
The fiber ports of two Ethernet optical fiber link adapters will always follow the principal of
"sending port connects to receiving port and receiving port connects to sending port", which is
Tx-Rx, Rx-Tx.
___________________________________________________________________________________________________
FOURSTAR Electronic Technology Co., Ltd. TEL:+86-838-2515543 FAX:+86-838-2515546
User Manual of Industrial Ethernet Optical Fiber Link Adapter FIB-IE-M
Normally on
Power on
Link fault pass function is
enabled
The Ethernet port is
connected with 100M
device
The Ethernet port
operates in full-duplex
mode
The Ethernet port is
correctly connected
Optical fiber is correctly
connected
Function
Enable link fault pass
Disable link fault pass
Blink
Product fault
Product fault
Product fault
The Ethernet port
data conflicts
The Ethernet port is
transferring data
The optical port is
transferring data
- 7 -
Off
Power off or product
failure
Link fault pass function
is disabled
The Ethernet port is
connected with 10M
device
The Ethernet port
operates in half-duplex
mode
The Ethernet port is
not connected
The optical fiber is not
connected
Remarks
Factory default
http://www.fourstar-dy.com