DS Services of America Pure Water Dispenser 100 Series Wie man reinigt - Seite 2

Blättern Sie online oder laden Sie pdf Wie man reinigt für Wasserspender DS Services of America Pure Water Dispenser 100 Series herunter. DS Services of America Pure Water Dispenser 100 Series 2 Seiten. Diy
Auch für DS Services of America Pure Water Dispenser 100 Series: Handbuch Reinigung (2 seiten)

Seite drucken

Air filter

No-spill

dispenser insert

Separator

Reservoir

Fig 5

Fig 6

Load water bottle FIRST.

Dispense water from

hot and cold faucets.

THEN plug in dispenser

and turn on the hot

tank switch.

Fig 4

Carefully pour hot water into the reservoir until it is ¾ full. Let the water sit

for 5 minutes (Fig 5). Always use caution when handling hot water.

Wearing disposable non-latex gloves, wipe the inside of the reservoir with a clean

cloth or soft brush. Use caution as the water may still be hot to the touch (Fig 6).

Completely drain the water from the reservoir by dispensing the water through

the hot and cold spigots into a container.

10. Repeat steps 7 and 9 to completely flush the dispenser. It is not necessary to wipe

the inside of the reservoir a second time.

11. Replace the separator and the no-spill dispenser insert. Wipe down the cooler and

the surrounding area to dry any water spills.

12. Wash your hands thoroughly with soap and water for at least 20 seconds. Install

a full water bottle on the dispenser. Dispense water through the hot and cold

spigots. Plug it in and turn on the hot tank heater switch located at the rear

of the dispenser.

WARNING:

spigots before plugging in and turning on the hot tank

switch. Failure to follow proper installation instructions

may cause damage to water dispenser.

Remove the separator by pulling it straight out.

Make note of the separator positioning before

removing so that it can be re-installed correctly.

Clean these parts with dishwashing soap and let

them dry thoroughly (Fig 4).

Dispense water through the hot and cold