DS18 INFINITE PWSI200A Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Batterieladegerät DS18 INFINITE PWSI200A herunter. DS18 INFINITE PWSI200A 6 Seiten.

BATTERY

CHARGER

200

PWSI200A

PRESENTATION

The PWSI200A Battery Charger is a high power supply that enables you to power and charge

automotive battery (s), delivering a maximum current of 200A at the output and operates in two modes:

14.4V or Auto ICS.

Auto Intelligent Charging System (ICS) enhances battery charging efficiency by extending battery life.

The PWSI200A Battery Charger has digital display to monitor voltage or current or accumulated charge

and leds battery level indicators and full charge.

TYPES OF READING

Voltage: Informs the voltage sent to the system.

Current: Shows the current consumed by the system.

Ampere Hour Meter: Informs how much charge has been accumulated by the battery during the

charging cycle, with this reading it is possible to know if the battery is in good working order. The counter

can be reset by holding the Read switch for 5 seconds. When it reaches 999 it must be reset to continue

reading the accumulated charge on the battery.

14.4V: Maintains the source operating with the output voltage at 14.4V.

Auto ICS: Allows the source output to operate at 14.4V when the system requires more power. In the

float operates with the output voltage in cycles of 13.8V for 5 minutes and 14.4V for 10 seconds. This

system prevents the excessive elevation of the potential of the plates, chemical phenomenon caused by

load stress, which decreases the useful life and the efficiency of the batteries.

1- Whenever you use the sound, charge the batteries until the Charge indicator on the Display shows

full charge. This means that the batteries will be 100% charged. The charging process does not damage

the batteries, because when they are fully charged, the Sources go into float mode.

2- We advise that when using the sound, immediately connect the Source. Do not wait for the batteries

to discharge to do so.

3- Use one socket per piece of equipment. Each PWSI200A Battery Charger consumes about 3000W

of the power grid respectively.

4- Use 70mm² cable at the PWSI200A output.

5- Do not install in high vibration environments such as speakers.