DSAN Limitimer ASL-4 Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch für Zeitschaltuhr DSAN Limitimer ASL-4 herunter. DSAN Limitimer ASL-4 5 Seiten. Speaker timer with remote signal light

Seite drucken

Signal Light Settings

Use DIP switches on the bottom of the signal light

to set which timer programs to display, whether

sound cues accompany light changes, which phase

lights are active and how the digital display

behaves. All settings are local can can be different

for each signal light connected to the timer.

Default Settings

DIP switches on

bottom of signal light

1 2 3 4 5 6 7 8 9 10

1-4. Select Timer Programs to be displayed

1. Display Program 1 [ON]

2. Display Program 2 [ON]

3. Display Program 3 [ON]

4. Display Program 4 [ON] (Session)

Since Program 4 can run in background, it might be

useful to use a separate signal light that is enabled

for Program 4 ONLY and another that is enabled for

Programs 1, 2 and/or 3 ONLY. A signal light that is

enabled for multiple programs displays the program

that is selected on the timer.

5. Continue counting after zero [ON] else, stop

display at zero. Note, in OFF mode, the clock

continues to run and red light stays on until user

presses "Stop." Beep / Blink continue, if set.

6. Sound volume. High [ON] Low [OFF]

7.+ 8. Sound Selection

7. ON 8. ON None*

7. OFF 8. ON Buzz

7. ON 8. OFF Ring

7. OFF 8. OFF Chime

9. Display top lights [ON]

10. Display digits [ON]

Display Lights:

Switch 9 =ON

Front lights

always active

Depressed position = ON

*An empty sound. "Beep"

pressed on the timer

outputs a cue to activate a

sound at a signal light that

is set for an audible sound.

Display Digits:

Switch 10 = ON

Signal Light Connections

Connect the signal light to the Limitimer console

with the 50-foot Cat-5 cable or the Cat-5–XLR

adapter (both included).

If Limitimer is used in debates or contests where

separate times are maintained for participants, set

the signal lights each to receive only a unique

program. Signal lights may be interconnected to

the timer console along a single cable run.

Caution: Cables carry 12V power.. Do not connect

to audio devices or data ports. Contact DSan for

pinouts to make your own cables.

Network Connections

Use IP-2000X "Network Extender" to make timer-

signal light connections over a network. For more

information, see www.dsan.com/Network .

Program 1

Program 2