DSC PC1150 Gebrauchsanweisung - Seite 7
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Sicherheitssystem DSC PC1150 herunter. DSC PC1150 13 Seiten. Tyco security system instruction manual
Programming Access Codes
Changing The Master Code
Enter [ ][5][current Master Code][new Master Code]
Press [#] to return to "Ready".
Record your new Master Code on the System Information page in this booklet.
Changing Access Codes
Up to 5 additional Access Codes (2 through 6) may be programmed. The 6th Access Code may be
established by your installer as a One-Time Use code.
To program a new code:
Enter [ ][5][Master Code]. Codes that are already programmed will be indicated by the Zone lights
and the "Ready" and "Armed" lights. The "Ready" light represents Access Code 5, and the "Armed"
light represents Access Code 6.
Enter the number of the Access Code to be programmed as a single digit, then enter the new 4-digit
Access Code. Press [#] to return to "Ready".
If an Access Code already exists, it will be replaced by the new code. Record your new code(s) on the
System Information page in this book.
To remove a code:
Enter [ ][5][Master Code][code number][
Do not erase the Master Code (code number 1).
NOTE: It is recommended that the factory-set Master Code [1234] not be used.
One-Time Use Code
The One-Time Use code is designed for entry and exit of the premises for one occasion only. The system
must be programmed by the installer for this option to be enabled. The 6th Access Code is the one-time
code.
To use this code, enter your one-time code as the 6th Access Code using the previously described
commands. When you leave the premises, arm your system with any Access Code except the newly
entered one-time use code. This one-time code is given to a person, such as service personnel, who will
enter the premises while the system is armed and you are away.
The one-time code user enters the premises and disarms the system using the one-time Access Code.
Upon leaving, the same code is used to arm the system. As soon as the system is armed, the one-time
code is erased and can not be used to re-enter the premises. A different code can be provided each time
for the one-time user.
Alarm Memory Display
If the "System" light is ON when the system is disarmed, an alarm has occurred during the last armed
period. The alarm memory will automatically be displayed when the system is disarmed (See Disarming
the System).
Press [ ] then [3] to display the zone which caused the alarm.
Press [#] to return to "Ready".
NOTE: The alarm memory is cleared each time the system is armed so that any alarms showing are
alarms that occurred only during the last armed period.
]. Press [#] to return to "Ready".
5