DSC PC51O Installationshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Installationshandbuch für Sicherheitssystem DSC PC51O herunter. DSC PC51O 20 Seiten. Pc51o
Auch für DSC PC51O: Gebrauchsanweisung (16 seiten)

Seite drucken

KEYPAD FUNCTIONS

Introduction

The Keypad provides complete control of the PC510 security system. The system can be completely

programmed from the keypad. The 4 zone lights provide alarm and status indication for the alarm circuits, and

three function lights advise the user of system status. The built-in sounder lets the user hear correct key entries

and other alert signals. Keypad alarms may be activated by pressing and holding the [F], [A] or [P] Keys. Note

that all keypad entries are made by pressing one key at a time.

Master Code

A default Master Code "1234" is factory programmed into the PC510. The Master Code is used to arm and

disarm the system, to reset the sounder after an alarm, to program additional Access Codes, and to perform

other user functions. The Master Code may be changed by using the [

Codes command.

Installer's Programming Code

A default Installer's Programming Code "0510" is programmed into the PC510. Using this code and the [

command, the installer can perform programming functions. This code should be changed by the installer after

the system is installed; refer to Programming Section [3].

Arming

Before arming the system, close all protected doors and windows and stop movement in areas covered by

motion detectors. If the "System" light is on, check for trouble conditions (refer to [

and correct the condition. Ensure that any bypassed zones are bypassed intentionally; refer to [

Code]: Bypass Zones. If the "Ready" light is not on, one or more zones are open; the system can only be

armed when the "Ready" light is ON.

To arm the system, enter a 4-digit Access Code. As each digit is entered, the keypad sounder will beep. When

the Access Code has been entered, the "Armed" light will come ON and the keypad will beep 6 times. If the

Access Code has been entered incorrectly, the keypad will sound a single long tone; press the [#] Key and enter

the Access Code again.

When an Access Code has been entered and the "Armed" light is ON, leave the premises through the

designated Entry-Exit door before the Exit Delay expires. At the end of the Exit Delay, all lights on the keypad

will be shut OFF except for the "Armed" light.

The default setting for the Exit Delay is 120 seconds. Refer to Programming Section [1] Zone Definitions for

information on zone types that are affected by the Exit Delay. Also refer to Programming Section [2] for

instructions on changing the Exit Delay.

Auto-Bypass/Home-Away Arming

If an Access Code is entered and the Exit-Entry zone is not activated, the system will arm with interior zones

automatically bypassed if those zones have been programmed as Home-Away Zones.

This feature is designed for the user who wishes to remain at home with the system armed. When this feature

is enabled, the user does not have to manually bypass zones programmed as Home-Away zones.

At-Home Arming

To eliminate the Entry Delay, arm the system by entering [

may then be made as in normal arming. The system will arm as described above in Auto-Bypass/Home-Away

arming whether an exit is made or not. The "Armed" light will FLASH to indicate that the system is armed and

that there is no entry delay on any of the Delay Zones. If any zone other than a Home-Away zone is activated,

an alarm will sound immediately.

∗

][5][Master Code] Program Access

∗

][9][Access Code]; an exit through a Delay Zone

∗

][8]

∗

][2]: Display Troubles)

∗

][1][Access