DAITEM SH423AX Installationshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationshandbuch für Sicherheitssystem DAITEM SH423AX herunter. DAITEM SH423AX 13 Seiten. Siren external

Seite drucken
To remove the lithium power pack, press on the unlocking key and slide the pack towards the right.
IMPORTANT
• When the siren is powered, it will issue a long beep and automatically switch to installation mode (tamper mechanism
disabled).
• If the siren does not respond as it should: - disconnect the power pack,

3. Recognition programming

Recognition programming allows the siren to be recognised by the control panel.
It must be done with the control panel and siren in installation mode. If they are not in installation mode, enter:
master code
IMPORTANT
• The siren does not need to be placed close to the control panel for recognition programming. In fact, it is advisable to move it
away from the panel (to a distance of at least 2 m).
• The control panel gives the siren a n° during recognition programming.
Siren recognition programming sequence:
"bip"
control panel"
Briefly press
Press and hold "Off"
the siren "test"
until the control panel
button
responds

4. Setting the parameters

IMPORTANT: all parameter-setting must be done using TwinLoad
www.daitem.co.uk.
The control panel and siren must be in installation mode to set the siren's parameters. If they are not, enter:
master code
The siren's parameters are factory-programmed.
Each parameter can nevertheless be modified using the control panel keypad.
To set the siren's parameters, first choose the parameters to be modified and then enter:
siren n°
parameter
n°

4.1 Delayed alarm sounding upon intrusion

Siren alarm sounding can be delayed by 60 seconds maximum. This gives users enough time to disarm the system before
the alarm siren sounds if, for instance, they have pressed the wrong button. To delay sounding, enter:
siren n°
Factory setting: 0 s
- wait for 2 minutes,
- reconnect the lithium power pack,
- check the siren issues a long beep as it should.
then
installer code
"bip, off,
"beeeep"
)
)
)
)
)
)
10 s max.
The siren issues
an audible signal to
confirm programming
then
installer code
parameter
value
from 0 to 60 s
"bip, siren n°"
)
)
)
)
The control panel
announces
the siren n°.
software available in the Daitem installers section at
®
3
IMPORTANT: the control panel and
siren issue three short beeps to
indicate a programming error. When
this happens, perform recognition
programming again from the start.