DAITEM SJ608AX Installationshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationshandbuch für Sicherheitssystem DAITEM SJ608AX herunter. DAITEM SJ608AX 8 Seiten. 2 function remote keyfob with information feedback, bi-protocol 4 function remote keyfob with information feedback,8 function 4 key remote keyfob with information feedback

Seite drucken

1. Changing the Battery

5. Radio link between the remote control keyfob and an Optwin

This step only concerns the remote control devices SJ604AX and SJ608AX.

IMPORTANT: An Optwin

radio link can be created for a key programmed for a TwinBand

deleted the key returns to its initial command n° setting.

5.1 Creating and deleting the radio link between the remote control keyfob and an Optwin

wireless product

This step is for creating (or deleting) a radio link between a keyfob and:

• an external receiver,

• a doorphone controller.

The keyfob can be programmed to recognise up to 16 products with 16 radio links per key.

A function-allocated radio link can be created or deleted following the same procedure, as described below:

Keyfob

1. Switch to radio link creation mode.

Remove keyfob battery compartment

cover to access Radio link button.

Press brieﬂy on the radio link creation

PB: red LED when the key is pressed

switching to orange when it is released to

indicate the change to radio link creation

mode for a maximum duration of 5 min.

4. Select the key to be associated (or deleted)

and validate the procedure

Press brieﬂy on the chosen key.

The LED lights up green for 1.5 s.

5.2 Deleting the radio links of a keyfob key

Example: the P2 key on the keyfob controls two separate lights via 2 external receivers.

Follow the procedure below to delete the 2 radio links with these 2 receivers.

Procedure:

1. press brieﬂy on the radio link creation pushbutton on the keyfob,

2. press and hold the keyfob P2 key for longer than 10 seconds.

The keyfob LED lights up green for 1.5 s to indicate that all of the selected key's radio links have been deleted.

command n°. If the radio link is

External receiver and doorphone controller

2. Switch to radio link creation or deletion mode.

Refer to the installation manual of each product.

3. Select the function.

Refer to the installation manual of each product.

wireless product