Anslut 004586 Betriebsanleitung - Seite 10

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Beleuchtungsanlagen Anslut 004586 herunter. Anslut 004586 12 Seiten. Solar cell lighting

Seite drucken
EN

SAFETY INSTRUCTIONS

•
Do not expose the battery to naked flames
or high temperatures.
•
The lamp and solar panel are weather
resistant, but do not immerse them in
water or any other liquid.
•
Do not look directly into the lamp when it
is switched on.
•
Do not use the lamp if the chimney is
damaged.
•
The light sources are not replaceable.
If the lamp stops working it must be
discarded.
•
Do not attempt to charge batteries with a
battery charger that is connected to the
mains, and do not attempt to run the
solar lamp from the mains.
Rechargeable batteries
IMPORTANT:
When replacing batteries – only use
rechargeable batteries.
•
Always buy the correct size and type of
battery intended for this purpose.
•
Remove the batteries from the lamp if it is
not going to be used for some time.
•
Recycle used batteries in accordance with
local regulations.
SYMBOLS
Approved as per
applicable directives.
Recycle discarded product
as electrical waste.
10

TECHNICAL DATA

Battery
1.2 V 1500 mAh Ni-MH AA
Luminous flux
Protection rating
DESCRIPTION
1.
Lamp
2.
Fastener
3.
Power switch
FIG. 1
ASSEMBLY
Make sure to put the lamp where it will get as
much sunlight as possible. Note that trees and
buildings etc. can put the solar panel in the
shade and affect its charging capacity.
Mounting on gutter
1.
Fit the fastener on the gutter with the
wing screw.
2.
Put the lamp on the fastener.
3.
Fasten the lamp to the fastener with a screw.
FIG. 2
Mounting on wall
1.
Mark out on the wall where the fastener is
to be mounted.
2.
Drill hole.
3.
If necessary, insert the supplied plug in
the drilled hole.
4.
Mount the fastener on the wall with a screw.
5.
Put the lamp on the fastener.
6.
Fasten the lamp to the fastener with a screw.
FIG. 3
20 lm
IP44