Daitron MFS50-15 Gebrauchsanweisung - Seite 2

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Stromversorgung Daitron MFS50-15 herunter. Daitron MFS50-15 3 Seiten. Mfs50 series

Seite drucken

2．Function explanation

2-1

Input Voltage

・ Input voltage range is single phase alternating current

85～264Vac(47～63Hz).

・ We recommend that you do not use this power

supply unit outside of it's normal intended use in

order to avoid any damage or malfunctions.

2-2

Output voltage setting

・ You can adjust Vout by using Output Voltage Adjustment

Potentiometer besides CN501connector.

・ You can increase Vout by turning clock wise and can

turn it the other way when you need to decrease.

・ Please use Vout within the following range.

・

Within +/- 10% rated output voltage.

Note: MFS50-5 can be used only within 5.0 to 5.5V range.

・

Do not use maximum output power.

・

Do not exceed rated output current.

2-3

Inrush Current

This model has inrush current limiting feature.

・

When inrush current limited circuit is on, please turn on

・

PSU after several tens of seconds passed.

2-4

Over Current Protection (OCP)

・

OCP feature will shut down the output when Output

current exceeds 110% than specification.

・

Remove the factor of the overload, then turn off.

Please turn on again after waiting for several minutes.

Don't keep using under the over current load condition

・

for over 10 seconds.

2-5

Over Voltage Protection (OVP)

・

When PSU detects Vout raises more than

specification, it automatically shut down the output.

・

OVP works while input power is supplying.

・

When you need to reset PSU, please turn on again

after several minutes disconnecting the AC input.

・

Please make sure to remove the OVP condition.

Otherwise it may works again to protect PSU.

2-6

Remote ON/OFF circuit

・ You can turn on/off while applying input.

・ You can apply voltage to the RC pin.

CN502 Connector

1kΩ

⑧ +R

⑨ -R

PSU

Voltage level (Pin#8 to 9)

SW OFF

Less than 0.8V, or Open

SW ON

More than 4.5V

If you apply more than 12.5V, please use resister

to control as you can specify below equation;

Voltage

4.5～12.5VDC

12.5V～24.5VDC

E－(1.1＋1000×0.005）

R〔Ω〕＝

2-7

Series Operation

・

Following <1> & <2> series operation can be used,

However be sure to use output current below the

Max Iout in small wattage one either of power supplies

which the series is connected.

PSU

Load

PSU

<1>

2-8

Parallel Operation

・

Parallel Operation can't be used for the purpose

to increase output current.

OFF

Vout

OFF

Resister Value

No need

See below

0.005

Load

PSU

Load

PSU

<2>