Anslut 427-630 Gebrauchsanweisung - Seite 17

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Flutlicht Anslut 427-630 herunter. Anslut 427-630 19 Seiten. Led floodlight

NoTE: The tripod stand is supplied assembled. To attach this floodlight you must first erect the stand.

• A: Centre screw knob

• B: Twist lock

• C: Leg hinges

• D: Cable storage

• E: Floodlight housing

• To open the legs push the spring pin upwards and, at the same time, pivot the leg down.

Release the spring pin whilst pivoting the leg and the pin will locate into one slot.

• To alter the stand height twist the locks (B) anti-clockwise to release them. Slide the tubes

to the desired height and tighten the twist locks clockwise.

• Attach the floodlight onto the crossbar (A) by tightening knob. Mount the screw and nut (A)

through the centre hole on the brackets of each this floodlight. Unscrew the centre knob (A)

for safe storage of the mains cable when not in use.

• To adjust the angle of the floodlight, loosen the screws located on either side of the bracket,

and then turn the floodlight until the desired angle is achieved. Then retighten the screws.

• Check that the floodlight is secure and that the stand is stable and has a firm footing. Make

sure that the cable is not catching on any sharp object and that the mains plug is adequately

protected against rain or moisture. Your floodlight is now ready for use .

WARNING

• Do not touch the hot surface by hand during adjustment or normal operation because of its

high temperature.

• Keep away from products that are inflammable or explosive.

• Do not look directly at the lamp.

• Do not use without glasses.

• Replace any cracked protective cover.

• The lamps must not exceed the rated power.

• The distance between the lamp and the object must be more than 1 m.

ASSEmBLY