Foxfury Lighting Solutions NOMAD 360 Produkthandbuch - Seite 16
Blättern Sie online oder laden Sie pdf Produkthandbuch für Beleuchtungskörper Foxfury Lighting Solutions NOMAD 360 herunter. Foxfury Lighting Solutions NOMAD 360 20 Seiten.
Auch für Foxfury Lighting Solutions NOMAD 360: Schnellstart-Handbuch (6 seiten)
Seite drucken
GENERAL MAINTENANCE TIPS
The Nomad
may depend on ambient conditions and battery health).
Maintain the light fully charged at all times, so that it is ready for use in
the event of an emergency .
If used outdoors in cold weather for an extended period of time allow the
Nomad
Lithium-Ion batteries have a 500 full charge cycle life (CC followed by a
CV cycle)*. When the light gets near this number of cycles, there will be a
decrease in usage time. *CC=Constant Current charge (fast rate)
The lithium-Ion batteries have a top-off or micro-charge life of around
1,200 cycles or more (CV only)*. If the Nomad
days, plug in the AC-DC Adaptor for 1 to 2 hours to bring the batteries
back up to peak charge. *CV=Constant Voltage charge (slow rate)
As needed, wash the Nomad
and a mild soap. When done, pat dry with a soft cloth.
STORING YOUR NOMAD
Make sure the light is powered OFF by pressing the Power/Mode Switch
until the light is no longer ON.
Be sure to CLOSE the Light Panels back into the 360 configuration
BEFORE lowering the Tripo-Scope
Put the Nomad
Tripo-Scope
Then, push the Light Head back into the Locking Sleeve.
If the AC-DC Adaptor or 12VDC Vehicle Adaptor is being used,
disconnect it from the Nomad
WARNINGS WHEN STORING
The Nomad
being ON for a while, the Nomad
heat) behind the Light Head will become warm to the touch (possibly hot)
depending upon the run time, setting, and/or air temperature. The warmer
the ambient air temperature is, the faster the head's temperature will
increase.
When it is time to put the Nomad
(usually 10–20 min) or protect hands (with work gloves or a cloth) when
adjusting the Light Head.
16
reaches a full charge in approximately 7 hours. (Charge time
®
to warm up to above 10°C/50°F before charging.
®
back into the Stored Position. Lower the
®
Poles by untightening the Tripo-Scope
®
depends on "ambient air" for cooling of its Light Head. After
®
360 using a soft washcloth, clean water
®
®
Poles.
®
and store.
®
360 Heatsink Fins (which help disperse
®
away , either wait for the unit to cool off
®
is unused for 60 to 90
®
Tightening Rings.
®