Foxpro Cabela's SLP Predator Call Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Jagdausrüstung Foxpro Cabela's SLP Predator Call herunter. Foxpro Cabela's SLP Predator Call 12 Seiten. Predator caller

Seite drucken

Slide the battery compartment door back on the TX35.

2. Operating Instructions

This section covers all sound playback and general operation instructions of the Cabela's SL

TX35 remote control, and FOXJACK 4 Decoy.

2-1 Playing Sounds

Before using the Cabela's SL

batteries installed.

Turn on the game call by turning the power switch clockwise to the 'on' position. The green LED

will illuminate indicating the power is turned on.

Verify that at least one of the speaker selector switches is in the 'on' position.

Turn on the TX35 remote control by pushing and holding the send/power button for 1 second.

The display will activate and display "SELECT SOUND".

Cycle through the sound list by using the sound selector buttons. Each button press steps

through the list one sound at a time. When you find a sound that you wish to play, push the

send/power button a single time.

In order to hear the sound, you must increase the volume level. You can press the volume up

button to increase the volume. The available volume level spans from 0 – 20. By default, the

volume is inaudible when you first turn it on.

If you wish to mute the sound, push the mute button a single time. To resume playback, push

mute a second time.

To switch sounds, repeat step number 4.

To turn off the game call: move the power switch to the 'off' position. To turn off the TX35: push

and hold the power/send button for about 4-5 seconds and then release (a message "TURNING

OFF" should briefly appear). Turning off the TX35 remote control does not result in termination

of sound playback on the game call. You can mute the game call first (see step 6) prior to

powering down, otherwise it will continue playing the sound.

2-2 Using the FOXJACK 4 Decoy

The Cabela's SL

Game Call features the

FOXJACK 4 Decoy mounted to the back

side of the housing. This section explores

the setup and operation of the FOXJACK 4

Decoy.

FOXJACK 4 General Setup:

Check that the FOXJACK 4

Decoy is properly connected to

the wiring harness inside the

battery compartment of the

predator call by removing the

FOXJACK 4 (see image to the right). The FOXJACK 4 is secured to the back of the predator call

with a knurled thumbscrew. Turn the thumbscrew counterclockwise to loosen and then lift up

the front of the FOXJACK 4 to gain access inside. Notice that there is a wire leading from the

FOXJACK 4 and connecting to a wiring harness located inside the battery compartment. If the

Game Call and TX35 remote control, make sure that both devices have good

Game Call,