AirTight 60397 Benutzerhandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Elektrowerkzeug AirTight 60397 herunter. AirTight 60397 2 Seiten. 120v air inflator/deflator
Seite drucken
IMPORTANT SAFETY INSTRUCTIONS
Read ALL instructions before using
DANGER - To reduce the risk of electric shock: Always unplug from the electrical outlet before
cleaning. Do not expose to rain or use near water, store indoors.
WARNING-To reduce the risk of burns, fire, electric shock, or injury to persons: Do not use this
with any solid-state speed control device. Using the built in air pump for a long time can
overheat and damage the pump, do not operate the air pump for more than 10 minutes.
This air pump has been specially designed to inflate/deflate air beds and other novelty
inflatables only. Do not attempt to alter or modify the air pump in any way to be used to other
large inflatables, doing so will void the warranty.
Carefully follow instruction of articles to be inflated. Never exceed recommended pressure.
Over inflation may burst the item and can cause serious injury. Never leave air pump
unattended during using. Do not use in wet conditions, or where the pump is exposed to
moisture. Never look into or point the inflation opening with your eyes while the air pump is
operating. Do not attempt to put hand or fingers into the inflation or deflation port at any time.
Unplug from outlet before putting on or taking off parts. Keep this air pump out of the reach of
children. Close supervision is necessary when this product is used by, or near children, or
persons with special needs. Use this product only for its intended use as described in these
instructions. Do not use any other attachments not recommended by the manufacturer.
Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or exposed to water. Keep the cord away from heated surfaces.
Never operate with the air openings blocked. Keep the air openings free of lint, hair, and other
foreign material. Never drop or insert any object into the air inlet or discharge port.
Do not use outdoors due to moisture potential, dry indoor household use only.
Do not operate where aerosol (spray) products are being used or where oxygen is being
administered. To disconnect, turn all controls to the off position, then remove plug from outlet.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances, Arrange cord away from traffic
areas and where it will not be tripped over.
SERVICING OF A DOUBLE-INSULATED PRODUCT
In a double-insulated product, two systems of insulation are provided instead of
grounding. No grounding means is provided on a double-insulated product, nor
should a means for grounding be added to the product. Servicing of a double-insulated product
requires extreme care and knowledge of the system, and should be done only by qualified
personnel. Replacement parts for a double-insulated product must be identical to those parts in
the product.
Use only a 2-wire extension cord that has a 2-blade polarized plug, and a 2-slot receptacle that
accepts the plug on the product. Make sure your extension cord is not damaged. When using
an extension cord, be sure to use one heavy enough to carry the current your product draws.
Do not use extension cords longer than 50 ft. the extension should be rated at least 300V and
with size no smaller than 18 AWG, cord type shall be no lighter than SPT-2, such as SVT, HPN,
SJT are acceptable cords. Overheating, short circuit and fire damage will result from
inadequate wiring.
2
OPERATING INSTRUCTIONS
WARNING -
To reduce the risk contact qualified electrician to repair or replace the damaged cord immediately.
Carefully follow the instructions on inflatable item when inflating.
Never exceed recommended pressure, otherwise serious injury might be caused by the
bursting of the item.
Never leave pump unattended while the pump is in use.
Do not keep/use the pump in a wet condition.
Never allow sand, small rocks, etc. to be sucked into inflation/deflation port when using this pump.
Never look inside or point the inflation port towards your eyes when the pump is on.
Stop at least for 5 minutes after 10 minutes of continuous use.
To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control
devices.
Never attempt to put your hands or fingers into the inflation/deflation port at any time.
Don't disconnect any electrical equipment with wet hands.
Don't move the pump with aid of the supply cord.
If the pump is not in use, please turn it off.
Don't use if the pump is damaged, especially the supply cord and the case.
Don't immerse the pump in liquid.
A periodically maintenance of the pump is necessary.
Do not put the pump down near hot surfaces ex. hotplate, oven etc. because the material can melt.
The pump should not be impelled by covering the ventilation openings with items such as
newspapers, table cloths, curtains, etc.
To reduce the risk of electric shock, do not connect unit of the extension cord to electric supply; and
contact a qualified electrician to replace the damaged cord immediately.
Carefully follow the instructions on inflatable item when inflating. Never exceed recommended
pressure, otherwise serious injury may occur by the bursting of the item.
Never leave pump un-attended while in use.
Do not keep/use the pump in a wet condition.
Never allow sand, small rocks, etc. to be sucked into the inflation/deflation port when using the pump.
Never look inside or point the inflation/deflation port towards your eyes when the pump is on.
Never attempt to put your hand or fingers into the inflation/deflation port at any time.
CARE, STORAGE AND MAINTENANCE
Save the original packing box for storage purpose.
Let the air pump cool down for at least 30 minutes before storage.
Store the air pump on a cool/dry place. Keep out of reach of direct sunlight and chemical substances.
The motor of this air pump is protected by a thermal overload protection device. This device detects
any over-heat condition and will turn off the motor automatically; the motor will be turned back on
automatically upon cooling down.
Use only damp cloth soaked in mild soap/detergent and water to clean the outer surfaces of the
pump. Do not use any kind of chemical or solvent. Always unplug the air pump and stow the cord
during cleaning. Do not twist the supply cord while in use.
This air pump does not contain any user serviceable part, any other servicing is to be performed by
an authorized service representative.
3