DSI MINI SURGERY MOTOR Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zahnärztliche Ausrüstung DSI MINI SURGERY MOTOR herunter. DSI MINI SURGERY MOTOR 15 Seiten. Micromotor for oral surgery
Seite druckenUSER MANUAL
Micromotor for oral surgery
01_26/04/2018
ATTENTION
1. Conformity to the Electromagnetic Compatibility Directive DOES NOT GUARANTEE the total absence of
interferences with other electronic devices; therefore:
The instruments MUST NEVER be used on or near patients who have pace-makers or other electronic implants.
•
2. Likewise, make sure the equipment does not interfere with other electronic devices that are vital for the life of
the patient or other persons.
3. The equipment is not protected against the risk of explosions or fires caused by mixtures of anesthetics or
inflammable gases; therefore:
Never use the equipment where mixtures of anesthetics or inflammable gases are present.
•
4. Electric parts connected to the supply mains are housed inside the equipment; therefore:
Make certain the supply mains is in perfectly safe condition before hooking up the instrument;
•
Never open the instrument's casing;
•
If the casing accidentally breaks, unplug the power cord before handling the equipment.
•
5. Water or other liquids that get electric parts inside the equipment wet may cause damage while the operator
risks electrocution. If liquids are split on the equipment, proceed as follows:
Shut off the equipment and unplug the power cord;
•
Immediately dry the equipment casing outside with a rag that absorbs well;
•
Wait enough time for any liquid that got into the casing to evaporate;
•
Make sure nothing inside or outside the equipment is still damp before plugging in and turning the equipment
•
back on.
6. Even though the equipment cannot run at full power when the handpiece is not connected, remember that
dangerous electric potentials are normally present at the contacts of the handpiece connector even at low
power; therefore:
Do not turn on the equipment if the handpiece is not connected to the cord;
•
Never detach the handpiece from the cord when the equipment is on;
•
Before connecting the handpiece to the cord, make certain the point where the handpiece is connected to the
•
cord is perfectly dry, in particular after the handpiece has been sterilized in autoclave.
The equipment is to be stored and used at normal room temperature, pressure and humidity.
•
No modification of this equipment is allowed.
Do not modify this equipment without authorization of the manufacturer.
If this equipment is modified, appropriate inspection and testing must be conducted to ensure continued safe
use of the equipment.
Page 3 of 15