ATS Water boy Installationshandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Installationshandbuch für Zubehör für Kraftfahrzeuge ATS Water boy herunter. ATS Water boy 13 Seiten. Stage 3
Seite drucken11/10/2008
37. Trim excess wire and enough loom to cover the switch wires.
38. Use supplied butt connectors, solder and heat shrink to wire in switch.
39. Fill the tank, check for leaks.
40. Reconnect the battery(s).
41. Test-drive the vehicle with the system armed. The LED will be green
when armed, yellow during stage 1, orange during stage 2, and red during
stage 3.
42. In a safe place, drive the vehicle such that EGT's are produced to activate
all three Water Boy stages. Check for leaks, and adjust the EGT settings
on the electronics box to tune performance.
Figure 5 - Cutoff Switch Wire Splice
1000-102-930 - INST
Cut and splice
this red wire
8