DSPPA MAG6701 Benutzerhandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Touch-Terminals DSPPA MAG6701 herunter. DSPPA MAG6701 20 Seiten. 100v network terminal
Auch für DSPPA MAG6701: Anweisungen (4 seiten)

Seite drucken

4. Operation Instruction

1. Volume adjustment:

Press "VOL+" or "VOL-" to adjust playing volume. Press "F1" to switch between volumes of

different audio source. Audio source options are AUX.1, MIC.2, MP3.3 ("AUX.1" is input volume.

"MIC.2" is acquisition volume. "MP3.3" is volume of AUX OUT output.)

After setting, it will go to countdown status automatically.

2. IP address modification:

Long press "Set" to enter IP address viewing mode.

Press "VOL+" or "VOL-" to select parameter that needs to be changed. (local IP, sub IP, gateway, and

subnet mask). After selecting, it will show parameters automatically.

Press "Set" again to enter IP address modification status. When parameter is flashing, press

to switch between parameters. Press "VOL+" or "VOL-" to increase and decrease. After

changing, press "Play/Pause" key to save parameters. If you do not press "Play/Pause" key, your

change will not be saved.

3. "IP" represents IP address. "SIP.1"/"SIP.2" represents IP address of sub-device. "GATE" represents gateway

(better not change). "MASK" represents subnet mask (better not change).

4. When the host is in playing status, insert U disk and press USB. Host will show "err" which means it cannot

play songs in U disk because priority level of host is higher than that of U disk.

Note: when eject or insert SD card, host must be power-off. Otherwise, SD card will be damaged. When digital

tube shows "err", your operation is invalid.

5. Installation

Note: user could find location of screws according to the installation diagram.

150mm

100V Network T erminal

VOL+

Net Service

STBY

Timing

100V Backup

Signal

Protect

USB

Set

VOL-

Installation diagram